Recalls that may apply to the 2012 Mitsubishi Lancer Evolution
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 13V446000 | 2013-09-19. POWER TRAIN:MANUAL TRANSMISSION. Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain model year 2008-2013 Lancer Evolution vehicles manufactured from December 12, 2007, through March 5, 2013. In the affected vehicles, the clutch master cylinder can fail. Built 2007-12-12 to 2013-03-05. |
|---|
| 2018588 | 2018-10-26. Visual System. On certain vehicles, water may drain from the windshield cowl area onto the front wiper link ball joint. Over time, this could result in corrosion and/or wear to the joint, which could result in the separation of the wiper link ball. If separation were to occur, the windshield wipers could become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the wiper link rod with a countermeasure one, and will replace the wiper motor crank arm with a new one. |
|---|---|
| 2016382 | 2016-07-29. Airbag. On certain vehicles operated in areas of heavy road salt usage, a mixture of snow, water and road-salt solution may infiltrate between the front impact sensor and the bracket that attaches it to the vehicle. Over time, repeated freezing/thawing cycles could cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. In the event of a crash, this could result in delayed deployment of the driver and passenger front airbags which would increase the risk of injury. Correction: Dealers will inspect the front impact sensor and replace it if it is found to be cracked. An updated designed bracket and cover will also be installed. |
| 2013316 | 2013-09-20. Powertrain. On certain vehicles, the clutch master cylinder may fail, resulting in an inability to disengage the clutch or to shift gears. This could result in unintended vehicle movement, increased stopping distances and engine stalling. Such an occurrence could increase the risk of a crash causing injury or property damage. Correction: Dealers will replace the clutch master cylinder. |
| 2012001 | 2012-01-04. Lights And Instruments. Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. An incorrectly manufactured turn signal lever could cause the auto-cancel function to become inoperative. The vehicle operator will, however, continue to be able to manually cancel the turn signals. Correction: Dealers will inspect and, if necessary, replace the turn signal lever. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.