WenmarOpen by Wenmar Pro

Service bulletins for the 2012 Mercedes-Benz Sprinter

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

109 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
Update2023-05-08. Service bulletin. AIR BAGS. Takata airbag recall campaign announcement
2022120013-12023-04-24. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. Emissions.
LI03.10-N-0758432023-03-03. Service bulletin. ENGINE AND ENGINE COOLING. Complaint Engine runs irregularly and it shakes. Indicator lamp lights up. Information: Fault codes for injectors and/or combustion misfires may be stored in the CDI control unit: • On engine 642 cylinder 6 is affected. • On engine 651 cylinder 2 is affected. Cause Charge air from the exhaust gas recirculation is condensed after being introduced into the charge air section. Information: Under certain operating conditions, condensation that has collected in the charge air cooler can enter the combustion chamber to a damaging degree and a damage profile is then generated (connecting rod bent). Remedy Perform following testing and diagnosis operations
LI00.19-N-0757492023-02-03. Service bulletin. ELECTRICAL SYSTEM. Complaint Various issues including control unit programming procedure will not complete successfully/no newer software found, communication faults, or sporadic malfunction of systems. Cause Aftermarket CAN device could be installed into the vehicle's CAN network. Such devices can be but are not limited to, remote start modules, CAN blockers, or high idle modules. Remedy A successful control unit programming session cannot be ensured while aftermarket devices are connected to the vehicle's CAN network. Some of the device companies supply a bypass to allow control unit programming.
20200600052022-12-19. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. 2020060005
20200400082022-12-19. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. 2020040008
20200600052022-09-19. Service bulletin. ENGINE AND ENGINE COOLING. 2020060005
20200400082022-09-19. Service bulletin. ENGINE AND ENGINE COOLING. 2020040008
LI49.20-N-0749422022-07-05. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, DIESEL. Complaint After installing new NOx sensors during the Approved Emission Modification (AEM), the Exhaust Aftertreatment Customer Service Measure in XENTRY/DAS displays incorrect NOx sensor part number values, X's, or no part numbers at all. The Approved Emission Modification (AEM) Exhaust Aftertreatment Customer Service Measure stops in error
20200600052022-06-27. Service bulletin. ENGINE AND ENGINE COOLING. 2020060005 Modification to the emissions control system
20200400082022-06-27. Service bulletin. ENGINE AND ENGINE COOLING. 2020040008 Modification to the emissions control system
NC3COD2ND2022-05-31. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. Modification to the emission control system.
LI01.00-N-0742102022-02-04. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. Complaint Oil loss from engine or visible traces of oil in the engine compartment. Cause To be determined in each possible situation Remedy Procedure for cause analysis: 1. Clean the engine if necessary. 2. Apply leak tracing powder. 3. Perform a test drive. 4. Locate the oil leak. 5. Perform the repair in accordance with the specific WIS document appropriate for the cause of the oil leak.
LI54.22-N-0740632022-01-06. Service bulletin. ELECTRICAL SYSTEM. Various complaints due to aftermarket OBDII device installed
LI00.30-N-0741182022-01-06. Service bulletin. ELECTRICAL SYSTEM. "The “monitor status this driving cycle (PID 41)” can be displayed as “disabled” in the generic scan tool although no monitor of this group is disabled "
20200600052021-12-20. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. 2020060005 Modification to the emissions control system
20200400082021-12-20. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. 2020040008 Modification to the emissions control system
LI8210N0487122021-12-20. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS. Headlamps and lamps fogged and/or leaking.
LI0709N06333862021-12-20. Service bulletin. UNKNOWN OR OTHER; SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM. Coolant, vacuum, temperature fault codes.
MB NC3DREZAHA Re2021-10-25. Service bulletin. WHEELS. Replace Wheel Speed Sensors
FTL NC3DREZAHA R2021-10-25. Service bulletin. WHEELS. Replace Wheel Speed Sensors
5113312021-06-02. Service bulletin. ENGINE AND ENGINE COOLING. Per Mercedes-Benz: In our continuing efforts to assure the proper performance of Mercedes-Benz Sprinter vehicles and to enhance the satisfaction of our customers, MBUSA is extending the warranty of the exhaust gas temperature sensor for the affected vehicles to a total of 11 years/ 120,000 miles from the vehicle's original New Vehicle Limited Warranty start date. This addendum to the exhaust gas temperature sensor coverage applies to the vehicle regardless of ownership.
Initial NCU - MY2020-10-19. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. Initial Notice - STOP SALE - Pending Emissions Modification
Pending Emission2020-10-19. Service bulletin. FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE. Daimler had reached ?Agreements in Principle? with various U.S. Authorities, as well as with plaintiff?s counsel, to settle regulatory and civil proceedings regarding diesel emissions in the USA.
Initial NCU MY192020-10-19. Service bulletin. FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE. Mercedes-Benz USA, LLC (?MBUSA?) has entered into an agreement with the United States Department of Justice (DOJ), the Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and the California Attorney General?s Office (CA AG) regarding the emission control system in certain MercedesBenz diesel vehicles. As part of this agreement, MBUSA will offer field measures referred to as the Approved Emission Modification (?AEM?) for the affected vehicles. As a result, certain vehicles covered under this notification cannot be sold or caused to be sold, or leased or cause to be leased, or introduced into commerce, or exported from the United States to another country, until after the AEM described in this notification is performed. An authorized Mercedes-Benz dealer will install the AEM at a later date at no cost to the Owner/Lessee.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.