WenmarOpen by Wenmar Pro

Service bulletins for the 2007 Mercedes-Benz SLR McLaren

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

33 on file from NHTSA, as of 2026-10-19.

By type

By component

Only bulletins with component: Brakes are shown. Show all

Bulletins, newest first
LI42.10-P-0787792026-10-06. Service bulletin. SERVICE BRAKES. Complaint Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is similar to a tire or wheel vibration, it is usually readily noticeable that it is distinctly different if it happens at all times or only while braking. Cause Although the cause of the vibration is most likely due to excessive lateral runout on the rotor or hub/wheel bearing, the system as a whole needs to be checked for other possible contributors. 1. Prior collision damage. 2. Excessive vehicle sitting times without rotating components. 3. Wheel bearing/hub lateral runout. 4. Wheel mating interface has been overtightened (did not follow WIS torque procedures). 5. Mating interfaces have been excessively modified (painted, gouged, bent, etc...). Remedy Read through the entire attached worksheet prior to performing. After performing, please review the final page and perform work accordingly. NOTE: This document is not pre‑authorization or otherwise dealing with warranty. This is intended for diagnostic purposes only. If there are any questions on how to proceed OR The work sheet has been performed and the vehicle has returned with the same concern. Please perform the measurements as seen in the worksheet again and open a TIPS case to the Body, Chassis, and Entertainment team.
CL- SBC Hydraulic Unit2026-04-29. Other. SERVICE BRAKES. The purpose of this letter is to advise you of additional benefits that Mercedes-Benz is providing to you regarding your vehicle ownership. What’s Included In our continuing efforts to assure the proper performance of Mercedes-Benz products and to enhance the satisfaction of our customers, Mercedes-Benz USA (“MBUSA”) is further extending the warranty on certain components that are part of the SBC/electro-hydraulic brake system to a total of 25 years and unlimited miles from the vehicle’s original warranty start date. This addendum to the existing SBC Extended Warranty coverage applies to the vehicle regardless of ownership. This warranty extension addendum covers the following SBC/electro-hydraulic brake system components: Hydraulic control unit, hydraulic pump, pressure reservoir, brake operating unit, front and rear wheel speed sensors, brake lamp switch, and
EW - SBC Hydraulic Unit2026-04-27. Warranty extension. SERVICE BRAKES. The warranty on the SBC Hydraulic Unit for MY 2003-2006 Model 211, MY 2006 Model 219, and Model Year 2003-2012 Model 230 was extended from the original 4 years/50,000 miles to 25 years with no mileage limitation. The SBC Hydraulic Unit extended warranty applies to all conditions that justify the replacement of the SBC Hydraulic Unit and specific listed components under the standard New Vehicle Limited Warranty terms and conditions. Please note that the warranty extension now includes: Model Year 2004-2012 Model 240, and Model Year 2005-2009 Model 199 vehicles. Notes: 1.Always check VMI to determine if a vehicle is covered under the 25 year / unlimited mileage extension. 2.Always close Campaign No. 2005070007 or Campaign No. 2005110001, as applicable, prior to replacing the SBC Hydraulic Unit. 3.Brake fluid changes required as part of the vehicle’s routine maintenance are not covered by the New Vehicle Limited Warranty or Extended Limited Warranty.
TSB-42-10-1092009-12-23. Service bulletin. SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:CALIPER; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DIFFERENTIAL PROPORTIONAL VALVE; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DRUM; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DRUM:WHEEL CYLINDERS; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DRUM:SHOES/LININGS; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DRUM:DRUM; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:PADS; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:ROTOR; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS; SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER. MERCEDES: CORROSION PROTECTION COATINGS FOR BRAKE COMPONENTS AND HARDWARE MAY BE DAMAGED AND OR STRIPPED AWAY IF HIGHLY CONCENTRATED ACID BASED CLEANERS ARE USED. ONCE THE CORROSION PROTECTION IS DAMAGED OR REMOVED THE BRAKE COMPONENTS AND OR HARDWARE CAN BEGIN TO CORRODE. INCLUDE ALL MODELS AND MODEL YEARS. *PE
2020322005-05-04. Service bulletin. SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS; ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS. LOCATION OF COOLANT HOSE ON CROSS MEMBER. MERCEDES-BENZ MODEL 199. MODEL YEAR UNKNOWN. *TT ( MODEL SLR 2005-2008) UPDATED 9/9/08. *PE

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.