Recalls that may apply to the 2003 Mazda Mazda6
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
Campaign 19V781000 may apply to this vehicle. NHTSA advises: do not drive until the repair is done.
Campaign 18V402000 may apply to this vehicle. NHTSA advises: do not drive until the repair is done.
Campaign 17V474000 may apply to this vehicle. NHTSA advises: do not drive until the repair is done.
By component
| 19V781000 | 2019-10-31. AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE. Mazda North American Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2004-2005 MPV, 2004 RX-8, and 2006-2007 Mazdaspeed6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling. Built 2002-08-05 to 2008-05-05. NHTSA advises: do not drive until the repair is done. |
|---|---|
| 18V402000 | 2018-06-15. AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE. Mazda North America Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2006-2007 Mazdaspeed6 and 2004 MPV vehicles nationwide. Mazda is also recalling 2005-2006 MPV vehicles in Alabama, Arizona, Arkansas, California, Delaware, the District of Columbia, Florida, Georgia, Hawaii, Illinois, Indiana, Kansas, Kentucky, Louisiana, Maryland, Mississippi, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, South Carolina, Tennessee, Texas, Virginia, West Virginia, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands. On July 9, 2019 this recall was expanded to include certain 2004-2011 RX-8 vehicles that were previously recalled under 16V-354 but have not yet been repaired. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these passenger air bag inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling. Built 2002-05-29 to 2008-05-05. NHTSA advises: do not drive until the repair is done. |
| 17V474000 | 2017-07-26. AIR BAGS:FRONTAL:DRIVER SIDE:INFLATOR MODULE. Mazda North American Operations (Mazda) is recalling certain model year 2003-2008 Mazda6, 2004-2008 RX-8, and 2006-2007 Mazdaspeed6 vehicles. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion and other factors, including manufacturing variability that, over time, could cause the inflator to rupture. Built 2002-05-29 to 2008-05-05. NHTSA advises: do not drive until the repair is done. |
| 03V531000 | 2003-12-16. FUEL SYSTEM, GASOLINE:DELIVERY. ON CERTAIN PASSENGER VEHICLES, THE FUEL SENDER UNIT (FSU) MAY HAVE BEEN IMPROPERLY INSTALLED IN THE FUEL TANK, PRODUCING AN INADEQUATE SEAL, AND FUEL MAY LEAK. Built 2002-10-02 to 2003-08-06. |
| 03V207000 | 2003-06-05. PARKING BRAKE:INDICATOR LIGHT. CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, "PASSENGER CAR BRAKE SYSTEMS." DURING PRODUCTION, THE FLOAT IN THE FLUID LEVEL SENSOR IN THE BRAKE RESERVOIR CAN BE FORCED OFF OF THE GUIDE RAIL DURING THE FILLING OF THE MASTER CYLINDER. Built 2002-10-02 to 2003-05-27. |
| 03V206000 | 2003-06-05. EXTERIOR LIGHTING:FOG LIGHTS. ON CERTAIN MINI VANS AND PASSENGER VEHICLES, THE SOCKET HOLDER IN THE FOG LIGHTS IS INSTALLED IN THE LAMP CASING USING PRESSURE. DURING OPERATION OF THE FOG LIGHT, THE HEAT FROM THE BULB CAN EXPAND THE SOCKET HOLDER. THE EXPANSION CAN FORCE THE SOCKET HOLDER REARWARD. AFTER REPEATEDLY BEING SUBJECT TO THIS EXPANSION, IF THE FOG LIGHT IS ALSO SUBJECTED TO VIBRATION DURING VEHICLE OPERATION, THE SOCKET HOLDER WITH THE BULB HOLDER AND THE WIRING HARNESS MAY SEPARATE FROM THE FOG LIGHT CASING. Built 2002-10-02 to 2003-05-27. |
| None found. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.