Recalls that may apply to the 2009 Mazda Mazda3
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 11V329000 | 2011-06-15. VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR. MAZDA IS RECALLING CERTAIN MODEL YEAR 2008-2009 MAZDA3 AND MAZDASPEED3 VEHICLES MANUFACTURED FROM JANUARY 7, 2008, THROUGH NOVEMBER 28, 2008. THE GROUND TERMINAL OF THE WINDSHIELD WIPER MOTOR MAY HAVE BEEN INADVERTENTLY BENT DURING ASSEMBLY. IF THIS CONDITION EXISTS THEN OVER TIME THE ELECTRICAL RESISTANCE OF THE MOTOR CIRCUIT MAY INCREASE UP TO A POINT THAT THE WINDSHIELD WIPERS WOULD NOT WORK. Built 2008-01-07 to 2008-11-28. |
|---|---|
| 10V374000 | 2010-08-12. STEERING:ELECTRIC POWER ASSIST SYSTEM. MAZDA IS RECALLING CERTAIN MODEL YEAR 2007-2009 MAZDA3 AND MAZDA5 VEHICLES MANUFACTURED FROM APRIL 2, 2007 THROUGH NOVEMBER 30, 2008. THESE VEHICLES MAY HAVE A CONDITION IN WHICH A SUDDEN LOSS OF POWER STEERING ASSIST COULD OCCUR AT ANY TIME WHILE DRIVING THE VEHICLE. Built 2007-04-02 to 2008-11-30. |
| 09V187000 | 2009-05-29. ELECTRONIC STABILITY CONTROL (ESC). MAZDA IS RECALLING 7,100 MY 2009 MAZDA3 VEHICLES EQUIPPED WITH DYNAMIC STABILITY CONTROL FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 126, "ELECTRONIC STABILITY CONTROL SYSTEM". THE YAW RATE MEASURED AFTER COMPLETION OF THE SINE WITH DWELL STEERING INPUT EXCEEDED THE TEST STANDARDS. Built 2008-07-01 to 2008-11-24. |
| 2011229 | 2011-06-15. Visual System. On certain vehicles, the ground terminal of the windshield wiper motor may have been inadvertently bent during vehicle assembly. Over time, the electrical resistance of the motor circuit may increase, causing the wiper motor to become inoperative. Loss of windshield wiping capability, should it occur during a rainy/snowy day, may compromise the driver's ability to see the road and its users, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will install an additional ground harness to the wiper motor. |
|---|---|
| 2010274 | 2010-08-13. Steering. On certain vehicles with Electro-Hydraulic Power Assist Steering (EHPAS), rust had formed inside the high-pressure pipe on the power steering system during manufacturing due to improper processing. Rust particles may detach from the pipe walls and enter the motorized power steering pump, causing damage to the pump bearings. As a result, gear lubrication may be reduced, leading to an increased load on the motor. Should this happen, there is the potential for the power steering system to enter the fail safe mode in order to prevent overheating, resulting in the power steering warning lamp to light and the motorized pump to stop which could lead to a loss of power assist and the required steering effort will increase. Correction: Dealers will flush the power steering system and repair as necessary. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.