C0051 on the 2016 Mazda Mazda2
The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.
Nobody has written a description of this code yet.
| 04-006-20-3707 | 2020-06-02. Service bulletin. Some customers may experience a TCS/DSC warning light and SCBS warning light (amber) illumination with DTC C0051:62 stored in PCM memory. DTC C0051:62 - EPS control module[when the vehicle is driven in a straight line, the difference between the steering angle (calculated by each sensor) and the steering angle (from the steering angle sensor) is greater than the specification]. This concern most likely occurs during the following situations: When the vehicle is turning in reverse, right after starting the engine. When the vehicle is going over a bump or a curb, right after starting the engine. This concern may be caused when the DSC HU/CM performs the steering center position calibration. During the learning process, if a shock is applied to the vehicle by a bump or curb etc., the steering center position may not be properly detected and creates a steering center position error. To eliminate this concern, the DSC HU/CM control software has been modified |
|---|
1 on file from NHTSA, as of 2026-10-19. See them in the bulletin list. A bulletin lists model years: read the document for which vehicles it concerns.