WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Mazda CX-5

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

603 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Body and frame are shown. Show all

Bulletins, newest first
09-022-16-31832017-02-08. Service bulletin. STRUCTURE. SOME CUSTOMERS MAY COMPLAIN OF THE POOR APPEARANCE OF THE PASSENGER AND/OR DRIVER SIDE A-PILLAR TRIM. THE LOWER PORTION OF THE TRIM MAY BECOME DISTORTED (AS SHOWN BELOW) DUE TO HIGH TEMPERATURES. TO ELIMINATE THIS CONCERN, THE SHAPE OF THE BODY FLANGE HAS BEEN IMPROVED DURING MASS-PRODUCTION TO ALLOW SUF-FICIENT A-PILLAR CLEARANCE.
1098M2017-02-07. Service bulletin. STRUCTURE. WHEN REMOVING PARTS FROM A VEHICLE, TAKE CAUTION OF THIS SYMBOL "R". FAILING TO REPLACE THE NON-REUSABLE PART MAY CAUSE A SYSTEM FAILURE.
09-044-16-32272016-12-03. Service bulletin. STRUCTURE:BODY:HATCHBACK/LIFTGATE. SOME VEHICLES MAY EXHIBIT A CONDITION IN EXTREMELY COLD TEMPERATURES (BELOW FREEZING) WHERE THE HATCHBACK WILL NOT LATCH (HALF LATCH) WHEN CLOSING. THIS IS CAUSED BY THE STOPPER RUBBER, A COMPONENT OF THE LIFTGATE LATCH AND LOCK ACTUATOR (A), HARDENING WHEN THE TEMPERATURE DROPS BELOW FREEZING. THE STOPPER RUBBER HAS NOW BEEN IMPROVED TO ELIMINATE THIS CONCERN.
09-043/152016-07-14. Service bulletin. SUSPENSION; STRUCTURE; EQUIPMENT. RATTLE/POP NOISE FROM INSTRUMENT PANEL AND/OR CREAK NOISE FROM A-PILLAR OVER ROUGH/BUMPY ROADS. WHILE DRIVING OVER ROUGH OR BUMPY ROADS, SOME VEHICLES MAY EXHIBIT A RATTLE/POP NOISE FROM THE INSTRUMENT PANEL AND/OR A CREAK NOISE FROM THE A-PILLAR. THE RATTLE/POP NOISE MAY BE CAUSED BY A LOW COWL PANEL (A) MOUNTING BOLT (B) TORQUE.
09-010/162016-07-14. Service bulletin. STRUCTURE. STAINS FOUND ON PAINT DURING PDI SOME VEHICLES MAY EXPERIENCE STAINS APPEARING ON THE HOOD, ROOF AND/OR TRUNK OF VEHICLE. THIS CONCERN IS MOST LIKELY TO BE FOUND IN COLD WEATHER AREAS JUST AFTER THE RAPGARD IS REMOVED AT PDI. THIS MAY BE CAUSED BY MOISTURE WHICH HAS BEEN TRAPPED AND CONDENSED BETWEN PAINT AND THE RAPGARD. THESE TYPES OF STAINS CAN BE REMOVED WITH HEAT GUN OR AN INFRARED DRIER. IF YOU ENCOUNTER THIS CONCERN DURING PDI, USE HEAT GUN OR AN INFRARED DRIER TO APPLY HEAT TO THE AFFECTED ARE TO REMOVE STAIN(S).
09-026-142016-03-31. Service bulletin. STRUCTURE:BODY:DOOR. SUMMARY TO BE PROVIDED ON A FUTURE DATE.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.