Recalls that may apply to the 1998 Mack RD
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 02V061002 | 2002-03-21. SUSPENSION:REAR. ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH DANA SPICER TANDEM DRIVE AXLE MODELS DS463, AN UNDERSIZED ATTACHMENT WELD MAY FRACTURE WITHOUT WARNING. Built 1998-10-01 to 2002-01-16. |
|---|---|
| 99V014001 | 1999-01-22. SUSPENSION:FRONT:WHEEL BEARING. VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCK CHASSIS EQUIPPED WITH MACK 16,000 LB., 18,000 LB., OR 20,000 LB. HEAVY DUTY STEERING AXLES. THE INNER WHEEL BEARING CONE FOR THE STEERING AXLE WHEEL HUB ASSEMBLY DOES NOT PROPERLY FIT ONTO THE MACK STEERING AXLE SPINDLE ASSEMBLY. IMPROPER FIT OF THE BEARING TO THE SPINDLE INCREASES THE STRESS LEVELS TO THE STEERING AXLE SPINDLE WHICH COULD CAUSE SPINDLE FAILURE. Built 1998-03-01 to 1998-10-06. |
| 2002189 | 2002-10-15. Brakes. On certain vehicles, additional axles were installed to increase the gross vehicle weight capacity but the parking brake capacity was not increased accordingly therefore not complying with CMVSS 121 regulations. Correction: The dealer will perform repairs as necessary. |
|---|---|
| 1999042 | 1999-03-17. Suspension. On certain vehicles, an improperly machined steering axle wheel hub inner wheel bearing cone can result in an improper fit onto the steering axle spindle assembly, which can eventually cause spindle failure. If the spindle fails there could be a loss of driver control and a crash without prior warning. Correction: Inner wheel bearing cones and cups will be replaced on affected vehicles. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.