Recalls that may apply to the 1999 Mack RB
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 02V061002 | 2002-03-21. SUSPENSION:REAR. ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH DANA SPICER TANDEM DRIVE AXLE MODELS DS463, AN UNDERSIZED ATTACHMENT WELD MAY FRACTURE WITHOUT WARNING. Built 1998-10-01 to 2002-01-16. |
|---|---|
| 00V230003 | 2000-10-04. VEHICLE SPEED CONTROL:ACCELERATOR PEDAL. VEHICLE DESCRIPTION: CLASS 8 TRUCKS EQUIPPED WITH FELSTED ELECTRONIC ACCELERATOR PEDALS. THE RETURN SPRINGS CAN BREAK ON THE ACCELERATOR PEDALS THAT ARE EQUIPPED WITH STAINLESS STEEL OR ELECTROPLATED WIRE RETURN SPRINGS. Built 1999-02-01 to 2000-08-31. |
| 2002057 | 2002-03-25. Suspension. On certain heavy-duty trucks equipped with Dana Spacer Tandem drive axle models DS463 an undersized attachment weld may fracture without warning. The loss of this attachment to the vehicle chassis can adversely affect vehicle or driver control. Correction: |
|---|---|
| 2002035 | 2002-02-27. Steering. Certain heavy-duty trucks equipped with tie rod sockets model ball sockets and manufactured by TRW. Certain of the tie rod ball-socket bearings have a below-specification case depth and/or hardness, which can lead to premature wear of the socket. If this condition occurs, the driver can lose partial control of the right front wheel, possibly resulting in a crash. Correction: Dealers will replace the defective tie rods. |
| 2002034 | 2002-02-27. Steering. Certain heavy-duty trucks equipped with drag link assemblies containing 24-DL model ball sockets and manufactured by TRW. Certain of the tie rod ball-socket bearings have a below-specification case depth and/or hardness, which can lead to premature wear of the socket. If this condition occurs, the driver can lose partial control of the right front wheel, possibly resulting in a crash. Correction: Dealers will replace the defective drag links. |
| 2000248 | 2000-10-26. Engine. On certain vehicles, the return springs on the accelerator pedals are made of stainless steel or electroplated music wire. The design fatigue stress of the stainless steel springs is in a range that would predict that some failures would occur. The music wire springs can fail due to stress risers created by electrical arcing during electroplating. Correction: Accelerator pedals will be replaced with ones equipped with return springs manufactured of music wire with one additional coil on each spring and with an organic coating, eliminating electroplating. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.