Recalls that may apply to the 1989 Mack CH
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Steering are shown.
| 90V048000 | 1990-03-12. STEERING:LINKAGES. THE UPPER AND LOWER PINCH BOLT ON THE STEERING PITMAN ARM AND THE LOWER PINCH BOLT CONNECTION ON SHEPHARD POWER GEARS WERE NOT TORQUED CORRECTLY. Built 1988-07-01 to 1990-02-01. |
|---|---|
| 89V086000 | 1989-05-22. STEERING: STEERING WHEEL/HANDLE BAR. STEERING WHEEL RETAINING NUTS MAY HAVE BEEN IMPROPERLY INSTALLED AND/OR TORQUED. Built 1987-08-01 to 1989-04-01. |
| 1990048 | 1990-03-27. Steering. ON VEHICLES WITH TRW POWER AND MANUAL STEERING GEARS AND SHEPPARD POWER GEARS, THE UPPER AND LOWER PINCH BOLT ON ALL STEERING PITMAN ARMS FOR TRW POWER AND MANUAL GEARS AND THE LOWER PINCH BOLT ON SHEPPARD POWER GEARS WERE POSSIBLY EMBRITTLED AND NOT TORQUED CORRECTLY. THIS COULD LEAD TO PROGRESSIVE LOOSENING AND/OR BOLT FAILURE RESULTING IN POSSIBLE LOSS OF STEERING CONTROL AND A VEHICLE CRASH. CORRECTION: NEW PINCH BOLTS AND WASHERS WILL BE INSTALLED AND PROPERLY TORQUED ON ALL AFFECTED VEHICLES. |
|---|---|
| 1989087 | 1989-06-14. Steering. NOTE: VEHICLES MANUFACTURED AT THE WINNSBORO, SOUTH CAROLINA FACILITY. THE STEERING WHEEL RETAINING NUTS MAY HAVE BEEN IMPROPERLY INSTALLED AND/OR TORQUED. IF EITHER OF THESE PROCEDURES OCCURED, IT IS POSSIBLE THAT THE STEERING WHEEL COULD DISENGAGE ITSELF FROM THE STEERING COLUMN CAUSING LOSS OF STEERING CONTROL. CORRECTION: STEERING WHEEL RETAINING NUTS WILL BE REPLACED AND RETORQUED ON ALL AFFECTED VEHICLES. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.