WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Kia Forte

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

149 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Lighting are shown. Show all

Bulletins, newest first
TSB_BOD055_R12021-10-02. Service bulletin. STRUCTURE; EXTERIOR LIGHTING. TECHNICAL SERVICE BULLETIN: INFORMATION FOR HEADLAMP CONDENSATION AND MOISTURE - This bulletin has been revised to include additional information. New/revised sections of this bulletin are indicated by a black bar in the margin area. This bulletin provides information relating to some Kia models that may exhibit fogging, condensation, and/or moisture inside a headlamp assembly. Generally, a fogging condition is considered normal and can be eliminated by turning on the headlamps with the engine running for up to 30 minutes or during normal driving conditions. Headlamp assembly replacement WILL NOT be necessary in most cases.
TSB_ELE1482020-02-04. Service bulletin. EXTERIOR LIGHTING. TECHNICAL SERVICE BULLETIN: HALOGEN HEAD LAMP LOW BEAM BULB CONNECTOR REPLACEMENT - This bulletin provides information regarding the procedure to repair the bulb connector on some 2010MY~ vehicles listed on the table below, which may exhibit a bulb connector concern. To correct this concern, replace the connector with a new and improved part.
TSB-ELE1252017-08-02. Service bulletin. EXTERIOR LIGHTING:TAIL LIGHTS; ELECTRICAL SYSTEM. TSB: OUTSIDE REAR COMBINATION LED LAMP ASSEMBLY REPLACEMENT - This bulletin provides the procedure to replace the outside rear combination lamp(s) (LED type) on some 2014-2015MY Forte Koup (YD) vehicles, produced from October 14, 2013 to July 1, 2014, which may experience an intermittently inoperative LED portion of the outside rear combination lamp due to a poor solder joint on the printed circuit board.
TSB BOD1322017-02-16. Service bulletin. EQUIPMENT; EXTERIOR LIGHTING:TAIL LIGHTS. ON SOME 2014-2015 MY FORTE VEHICLES, CUSTOMERS MAY COMPLAIN ABOUT WATER DROPLETS FORMING INSIDE THE REAR TAIL LAMP LENSES FOLLOWING A RAINSTORM OR AFTER WASHING THEIR VEHICLE. THESE WATER DROPLETS ARE MORE VISIBLE AT NIGHT AND THE QUANTITY OF WATER PRESENT IS MORE THAN JUST A THIN FILM OF CONDENSATION WHICH MAY NOT EASILY EVAPORATE. THIS CONCERN IS CAUSED BY A GAP BETWEEN THE TAIL LAMP HOUSING GASKET AND VEHICLE BODY WHICH ALLOWS WATER TO INFILTRATE INTO THE TAIL LAMP. TO RESOLVE THIS CONCERN, ORDER NEW FOAM GASKETS AND INSTALL THEM BETWEEN THE LEFT AND RIGHT TAIL LAMPS AS REQUIRED AND THE BODY OF THE VEHICLE, AS OUTLINED IN THE TSB.
TSBBOD1322017-01-25. Service bulletin. EXTERIOR LIGHTING:TAIL LIGHTS; STRUCTURE; EQUIPMENT. TSB: WATER LEAK/CONDENSATION IN REAR COMBINATION TAIL LAMP(S) - ON SOME 2014~2015MY FORTE (YD) VEHICLES, CUSTOMERS MAY COMPLAIN ABOUT WATER DROPLETS FORMING INSIDE THE REAR TAIL LAMP LENSES FOLLOWING A RAINSTORM OR AFTER WASHING THEIR VEHICLE. THESE WATER DROPLETS ARE MORE VISIBLE AT NIGHT AND THE QUANTITY OF WATER PRESENT IS MORE THAN JUST A THIN FILM OF CONDENSATION WHICH MAY NOT EASILY EVAPORATE. THIS CONCERN IS CAUSED BY A GAP BETWEEN THE TAIL LAMP HOUSING GASKET AND VEHICLE BODY WHICH ALLOWS WATER TO INFILTRATE INTO THE TAIL LAMP. TO RESOLVE THIS CONCERN, ORDER NEW FOAM GASKETS AND INSTALL THEM BETWEEN THE LEFT AND RIGHT TAIL LAMPS AS REQUIRED AND THE BODY OF THE VEHICLE.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.