Recalls that may apply to the 2000 Kenworth W900
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about SUSPENSION are shown.
| 03V125000 | 2003-04-01. SUSPENSION:FRONT:HUB. ON CERTAIN TRUCKS EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY. Built 1998-09-02 to 2001-12-06. |
|---|---|
| 02V061001 | 2002-02-27. SUSPENSION:REAR. ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH REPLACEMENT DANA SPICER TANDEM DRIVE AXLE MODELS DS463 AND DS521, INSTALLED ON VEHICLES FROM MAY 1, 2001 THROUGH FEBRUARY 1, 2002, AN UNDERSIZED ATTACHMENT WELD MAY FRACTURE WITHOUT WARNING. Built 1998-07-09 to 2000-09-22. |
| 01V167001 | 2001-05-17. SUSPENSION. VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH CHALMERS 1000 SERIES AND 800 SERIES SUSPENSION KITS. THESE SUSPENSION KITS MAY HAVE INSUFFICIENT PENETRATION OF THE WELD ATTACHING THE TORQUE ROD EYE TO THE TORQUE ROD TUBE. Built 2000-05-11 to 2000-10-18. |
| 01V051000 | 2001-02-20. SUSPENSION:FRONT:CONTROL ARM:LOWER ARM. VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH 54" REAR AXLE SPACING CONFIGURATION OF THE AIRGLIDE 200 SUSPENSION WITH THE SERVICE APPLICATION IDENTIFIED AS LOGGER, DUMP TRUCK, OR TANKER. THE REAR SUSPENSION IS REGULARLY SUBJECTED TO EXTREME ARTICULATION, RESULTING IN FLEXING OF THE JOINT. Built 1996-02-19 to 2001-02-09. |
| 2001138 | 2001-05-31. Suspension. Certain heavy duty trucks equipped with Meritor FG941 steer axles. The Gross Axle Weight Rating (GAWR) was determined incorrectly and over-stated on the vehicle certification label. Correction: Vehicles will be remedied either by assigning the proper weight rating or, if possible, by changing the necessary components to meet the currently assigned weight rating. |
|---|---|
| 2001104 | 2001-05-16. Suspension. On certain vehicles, the rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint. Failure of the lower sway arm attaching bolts could result with possible loss of vehicle control. Correction: Dealers will replace the lower sway arm brackets. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.