Recalls that may apply to the 2001 Kenworth T600
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Other are shown.
| None found. |
| 2003121 | 2003-05-05. Other. On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: Dealers will replace the bracket pins. |
|---|---|
| 2001239 | 2001-09-10. Other. Certain heavy duty trucks built between March 5, 2001 and June 4, 2001. Fail to comply with the requirements of C.M. V. S.S. 103, "windshield defrosting and defogging systems." the mode door in a HVAC system can become inoperable. The mode door cam and actuator could bind, causing the cam retaining tabs to shear off. This failure may inhibit the ability to direct air blowing from the HVAC system to the windshield, potentially reducing the driver's visibility. Correction: Dealers will inspect the mode door operation and replace the HVAC cab mode housing assembly if necessary. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.