Recalls that may apply to the 1990 Kenworth T400
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 91V090000 | 1991-06-10. VISIBILITY:WINDSHIELD WIPER/WASHER:LINKAGES. SPRAGUE WIPER ASSEMBLY PIVOT CAN SEIZE DUE TO GALVANIC CORROSION BETWEEN THE ZINC-PLATED STEEL SHAFT AND THE BRONZE BUSHINGS. Built 1988-05-01 to 1990-08-01. |
|---|---|
| 91V044000 | 1991-03-14. SUSPENSION:REAR. REAR AXLE STABILIZER (SWAY) BAR MAY NOT HAVE BEEN PROPERLY HEAT TREATED. Built 1989-05-01 to 1989-10-01. |
| 91V043000 | 1991-03-14. SERVICE BRAKES, AIR. AIR BRAKE SYSTEM WAS MODIFIED BY ADDING A LONGER AIR LINE BETWEEN THE ABS SOLENOID AND THE TRANSFER TEE TO SIMPLIFY MANUFACTURING. THIS MODIFICATION CAUSED THE TRUCKS TO BE IN NON-COMPLIANCE WITH FMVSS 121, BRAKE TIMING TEST. Built 1989-08-01 to 1991-01-01. |
| 1991091 | 1991-06-11. Visual System. THE SPRAGUE WIPER ASSEMBLY PIVOT CAN SEIZE DUE TO GALVANIC CORROSION BETWEEN THE ZINC-PLATED STEEL SHAFT AND THE BRONZE BUSHING CAUSING THE WIPER ARM/BLADE ASSEMBLY TO STOP WIPING THE WINDSHIELD. THIS COULD CAUSE REDUCED DRIVER VISIBILITY DURING INCLEMENT WEATHER AND RESULT IN A VEHICLE CRASH. CORRECTION: SPRAGUE WIPER ASSEMBLY PIVOT WILL BE REPLACED WITH AN ASSEMBLY NOT SUSCEPTIBLE TO GALVANIC CORROSION. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.