Recalls that may apply to the 2001 Kenworth T300
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Steering are shown.
| None found. |
| 2001217 | 2001-08-27. Steering. Certain heavy duty trucks equipped with TRW tie rod ends on certain meritor axles. The tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness. This can lead to premature wear with possible separation of the ball stud from the socket, increasing the risk of loss of control of the vehicle. Correcton: Dealers will remove and replace all affected tie rods and drag links with different designed ends. |
|---|---|
| 2001216 | 2001-08-27. Steering. Certain Kenworth vehicles manufactured between March 1996 and September 11,2001 model year T300 trucks equipped with 10,000 or 12,000 pound Dana front axles. A condition called brake "sprag", which is characterized by a noise at the end of an applied stop, can develop in the brake system. This noise is the result of a pulsation of the brake lining with the brake drum during brake application. These noise vibrations occur at the resonant frequency of the front axle cross-tube assembly and cause unusually high strain forces in the threaded portion of the tie rod ends that are connected to the cross-tube. Failure of the tie rod end can cause loss of steering control and possibly result in a vehicle crash. Correction: Dealers will replace the brake lining on the front axle of each vehicle with a lining made of a different composition. In addition, the tie rod ends will be replaced free of charge. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.