WenmarOpen by Wenmar Pro

Recalls that may apply to the 2001 Kenworth T2000

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
03V2340002003-07-01. UNKNOWN OR OTHER. ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH VERTICAL TAIL PIPES, THE FRAME ACCESS GRABHANDLE IS MOUNTED TOO HIGH. Built 2001-03-24 to 2001-03-24.
03V1680002003-05-05. TRAILER HITCHES:FIFTH WHEEL ASSEMBLY. ON CERTAIN TRUCKS EQUIPPED WITH JOST INTERNATIONAL JSK 37U SERIES FIFTH WHEELS, A FATIGUE CRACK CAN DEVELOP IN THE BRACKET PIN WELD UNDER CERTAIN LOADING CONDITIONS. Built 2001-07-18 to 2003-05-15.
03V1250002003-04-01. SUSPENSION:FRONT:HUB. ON CERTAIN TRUCKS EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY. Built 1998-09-02 to 2001-12-06.
01V3350002001-10-25. POWER TRAIN:DRIVELINE:UNIVERSAL JOINT. VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE DRIVELINE U-JOINT FASTENERS AT THE OUTPUT YOKE OF THE TRANSMISSION WERE IMPROPERLY TIGHTENED. Built 2001-09-26 to 2001-10-10.
01V0510002001-02-20. SUSPENSION:FRONT:CONTROL ARM:LOWER ARM. VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH 54" REAR AXLE SPACING CONFIGURATION OF THE AIRGLIDE 200 SUSPENSION WITH THE SERVICE APPLICATION IDENTIFIED AS LOGGER, DUMP TRUCK, OR TANKER. THE REAR SUSPENSION IS REGULARLY SUBJECTED TO EXTREME ARTICULATION, RESULTING IN FLEXING OF THE JOINT. Built 1996-02-19 to 2001-02-09.
Canada: Transport Canada, as of 2026-10-19
20031212003-05-05. Other. On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: Dealers will replace the bracket pins.
20012172001-08-27. Steering. Certain heavy duty trucks equipped with TRW tie rod ends on certain meritor axles. The tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness. This can lead to premature wear with possible separation of the ball stud from the socket, increasing the risk of loss of control of the vehicle. Correcton: Dealers will remove and replace all affected tie rods and drag links with different designed ends.
20011042001-05-16. Suspension. On certain vehicles, the rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint. Failure of the lower sway arm attaching bolts could result with possible loss of vehicle control. Correction: Dealers will replace the lower sway arm brackets.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.