Recalls that may apply to the 2025 Kenworth L770
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
Campaign 24V433000 may apply to this vehicle. NHTSA advises: do not drive until the repair is done.
By component
| 25V436000 | 2025-06-26. EXTERIOR LIGHTING:LIGHTING CONTROL MODULE:SOFTWARE. PACCAR Incorporated (PACCAR) is recalling certain 2024-2026 Kenworth T480, T680, T880, W990, Peterbilt 520, 536, 537, 548, 567, 579, 589, 2025 Kenworth T180, Peterbilt 535, 2025-2026 Kenworth T280, T380 and L770 vehicles. The tail brake light, upper and lower beam headlights, reverse light, and turn signal may not illuminate as intended. In addition, the lift axles, if lowered, may revert to a raised position, or oscillate up and down when the signal warning lights are activated. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices and Associated Equipment." Built 2024-09-16 to 2025-05-23. |
|---|---|
| 24V433000 | 2024-06-12. STEERING:LINKAGES:TIE ROD ASSEMBLY; STEERING:LINKAGES:DRAG:LINK:CONNECTION. PACCAR Incorporated (PACCAR) is recalling certain 2025 Kenworth K270, K370, L770, T280, T380, T480, T680, T880, W900, W990, 2025 Peterbilt 220, 520, 536, 537, 548, 567, 579, and 589 trucks. The tie rod or drag link assembly may contain an improperly heat-treated ball stud, causing the ball stud to break. NHTSA advises: do not drive until the repair is done. |
| 24V044000 | 2024-01-25. STEERING. PACCAR Incorporated (PACCAR) is recalling certain 2024-2025 Kenworth T280, T380, T480, T680, T880, L770, W990, and 2024-2025 Peterbilt 389, 520, 535, 536, 537, 548, 567, 579, 589 trucks. The steering gear assemblies may have been assembled incorrectly with fewer recirculating balls than are required, which may result in a loss of steering control. |
| 2025357 | 2025-06-26. Lights And Instruments. Issue: On certain trucks, a software problem could cause the stop lamps, low beam headlamps, high beam headlamps, reverse lamps and turn signal lamps not to turn on, or to turn on unexpectedly. This problem could also cause the lift axle(s) to raise or lower on their own. Safety Risk: Lamps that don't work properly could reduce visibility and increase the risk of a crash. Lift axles that move unexpectedly could increase the risk of injury. Corrective Actions: PACCAR will notify owners by mail and advise you to take your truck to a dealership to update the vehicle software. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.