Recalls that may apply to the 2008 Kawasaki KLR650
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 07V244000 | 2007-06-07. STRUCTURE:MOTORCYCLE:KICKSTAND/CENTER STAND. ON CERTAIN MOTORCYCLES, THE SPRING RETAINING PIN ON THE FRAME MAY NOT HAVE BEEN COMPLETELY WELDED IN PLACE AND COULD FALL OUT, ALLOWING THE SIDESTAND TO DROP INTO THE "PARKING" POSITION. Built 2007-03-26 to 2007-03-28. |
|---|
| 2009069 | 2009-03-03. Electrical. On certain motorcycles, the main wiring harness can chafe against the frame, causing the engine to stop running. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the rider's reactions, could increase the risk of a crash. Correction: Dealers will reinforce and reroute the main wiring harness. |
|---|---|
| 2009068 | 2009-03-03. Other. On certain motorcycles, the muffler mount bolts could loosen due to heat expansion of the exhaust pipe and vibration. Should the bolts loosen completely, the muffler could separate from the motorcycle, which could result in a vehicle crash causing personal injury or death. Correction: Dealers will remove the paint from the muffler mount tabs and replace the mount bolts, nuts, washers and gasket. |
| 2008383 | 2008-10-20. Lights And Instruments. On certain motorcycles, the turn signal mounting stalk(s) can break causing failure of the turn signal to clearly indicate the rider's turn intentions. This situation could lead to a crash causing personal injury or death. Correction: Dealers will replace all four turn signal assemblies. |
| 2007349 | 2007-10-31. Other. On certain motorcycles, insufficient tightening torque may have been applied to the muffler mounting bolts during vehicle assembly. Should the bolts loosen, the muffler could separate from the motorcycle and impact nearby persons or objects resulting in personal injury and/or vehicle and property damage. Correction: Dealers will tighten muffler mounting bolts to the proper torque. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.