WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Jeep Wrangler

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

836 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
S23070000012023-04-17. Service bulletin. ENGINE AND ENGINE COOLING. Customer complaint may include a coolant leak, or, a coolant leak is detected during a routine oil change inspection.
9003357a2023-04-17. Service bulletin. ENGINE AND ENGINE COOLING. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY review and follow instructions from the latest STAR Online S1809000007 available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
90033572023-04-17. Service bulletin. ENGINE AND ENGINE COOLING. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
91001342023-04-17. Service bulletin. ENGINE AND ENGINE COOLING. Engine When replacing a GMET4 long block from a 2021 JL or older, you will need to carry over the injector wiring harness from the original engine, and the Fuel pressure sensor should be replaced with part number: 68212572AB.
S21090000042023-01-17. Service bulletin. ENGINE AND ENGINE COOLING. Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle.
90037042023-01-09. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
07001222023-01-09. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fastenersto possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low.
S19080001592023-01-09. Service bulletin. ENGINE AND ENGINE COOLING. MIL Lamp On, DTC P0330 Knock Sensor 2 Circuit
S22080000732023-01-09. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM). No Start, After Flash And Or PCM Replace, DTC P0513 Invalid Skim Key Setting
07001222022-12-19. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fasteners to possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low.
S22090000042022-12-19. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. If a Mopar oil filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils.
09012222022-12-12. Service bulletin. ENGINE AND ENGINE COOLING. Spark Knock/Engine Symptoms This bulletin involves cleaning the piston heads and cylinder head combustion chambersto resolve a spark knock condition being caused by oil intrusion through the PCV system. The customer may describe a knocking or pinging noise coming from the engine upon acceleration.
90042192022-11-07. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL; ENGINE AND ENGINE COOLING. PUMP, Water (Water Pump Inlet Tube) For concern of leak at water pump, please check and re-torque water pump inlet tube fasteners as described in Service Bulletin 07-001-20 before replacing the water pump. Please also check the gasket from the block to the water pump. This gasket can be serviced separately.
S22070000022022-10-31. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM. Coolant leak
S22070000022022-10-31. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM. Coolant leak
18022202022-10-17. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more ofthe following DTCs:P012A - Turbocharger/Supercharger Inlet Pressure Sensor 1. P012C - Turbocharger/Supercharger Inlet Air Pressure Sensor 1 Circuit Low. P012D - Turbocharger/Supercharger Inlet Air Pressure Sensor 1 Circuit High. P0607 - ECU Internal Performance. P06EF - Engine Restart Performance. P050B - Cold Start Ignition Timing Performance. P0456 - EVAP System Small Leak.If DTC P0456 is present use the wiTECH Small Leak Verification Test (SLVT) to determine if a leak is present in the system. P0128 - Thermostat Rationality. P0507 - Idle Speed Performance Higher Than Expected. Customers may also describe the following condition:Excessive radiator fan noise when the A/C is on MAX output. In addition, the following software enhancements are available:Electric Vacuum Pump (EVP) update. Fan noise reduction.
07001202022-10-17. Service bulletin. ENGINE AND ENGINE COOLING. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fasteners to possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low.
07001222022-10-17. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fastenersto possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low.
7001222022-10-17. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fasteners to possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low.
90037042022-09-26. Service bulletin. SEATS; FUEL SYSTEM, GASOLINE; AIR BAGS; POWER TRAIN; BACK OVER PREVENTION; ENGINE AND ENGINE COOLING. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
S21090000042022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle.
S1918000008RevB2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Customer?s complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above.
S21080001462022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Check Engine Lamp Comes On, CAN C Loss Communication DTC?s Setting Stored Or Active Intermittently
S1809000007RevC2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Customer Complaint May Include Engine Oil Leak Or Consumption
S21230000202022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. A Buzz, Squeak, Rattle (BSR), Clicking Noise Heard From Left Side Of The Freedom Top.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.