Recalls that may apply to the 2018 Jeep Wrangler
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Steering are shown.
| 18V343000 | 2018-05-25. STEERING. Chrysler (FCA US LLC) is recalling certain 2018 Jeep Wrangler vehicles. The intermediate steering shaft may not have been properly welded causing a split where the external spline is formed. Built 2018-01-30 to 2018-01-31. |
|---|
| 2018539 | 2018-09-28. Steering. Certain vehicles may have been built with an improperly welded front track bar bracket. This could result in the bracket separating from the frame, which would reduce steering response and increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair the front track bar bracket welds as necessary. Note: Prior to complete separation of the bracket from the frame, a driver may notice a front end noise, an off-center steering wheel position, a “Service Electronic Stability Control” message and/or Electronic Stability control light on in the instrument cluster. |
|---|---|
| 2018281 | 2018-05-25. Steering. On certain vehicles, the steering intermediate shaft may not have been properly manufactured. If the shaft were to fail, the steering response could be reduced, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and replace the steering intermediate shaft as necessary. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.