Service bulletins for the 2026 Jeep Compass
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
147 on file from NHTSA, as of 2026-10-19.
About C10EA on the 2026 Jeep Compass: what the code means, and the bulletins and recalls about the same components.
By type
By component
By trouble code
By topic
Only bulletins with trouble code: C10EA are shown. Show all
| 08-314-26 | 2026-09-03. Service bulletin. ELECTRICAL SYSTEM. Headlamp And Dash Wiring Not Secure Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● C10D0 - Electronic Park Brake System Failure. ● C10EA - 01 Left Park Brake Actuator - General Electrical Failure. ● C10D0 - 4B Electronic Park Brake Module - Over Temperature. ● C10D0 - 92 Electronic Park Brake Module-Performance or Incorrect Operation. ● C10D0 - 9A Electronic Park Brake Module-Component or System Operating Conditions. ● C2222 - 68 Improper Power Down-Event Information. ● U2006 - 64 EPB Status - Signal Plausibility Failure. NOTE: The above DTCs will only occur when there has been wire damage. Repair the damage following published repair methods. Submit repair claims following standard Warranty repair methods. Customers may also experience one or more of the following: ● 'Service Electric Park Brake' message on in Instrument Panel Cluster (IPC). ● Multiple warning lamps on. ● Vehicle does not start. This bulletin involves inspecting and possibly rerouting and securing a wiring harness. |
|---|---|
| 9100620 | 2025-07-09. Service bulletin. ELECTRICAL SYSTEM. MP EPB SERVICE BRAKE MESSAGE ON THE CLUSTER AND LED LIGHT ON If any of the following DTCs come as ACTIVE: C10ED-00 Electronic Park Brake Switch LED- C10CD-01 Electronic Park Brake Switch-General Electrical Failure 1. Confirm customer's concern 2. If the DTCs come as STORED, clear them prior to performing any service steps. If the DTCs come as ACTIVE 3. Check that the battery connectors are properly seated as well as the ground connector. 4. Try disconnecting the battery for 5min to reset the module. 5. If the issue with the EPB is still present and there are ACTIVE DTCs, check for any loose connection at the Park Brake Switch or Brake System Module BEFORE replacing the Switch. If after disconnecting the switch and the module, any DTC goes from ACTIVE to STORE, clear them and do not replace the switch. 6. If after following steps 1 to 5 the Park brake switch is not working, replace the switch. Note: If there is any other DTC are present, review Brake System Module BEFORE replacing the switch. C10EA-00 Left Park Brake Actuator- C10EC-00 Park Brak Actuator Correlation C10EB-00-RIGHT PARK BRAKE ACTUATOR |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.