Service bulletins for the 2015 Jeep Compass
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
176 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
| 56046094A | 2018-12-17. Service bulletin. VEHICLE SPEED CONTROL:CRUISE CONTROL. Part Description: Cruise Control Switch Issue Description: Before ordering or replacing this part please contact Dennis Gauthier at cell (248) 613-9756. If no response is received within 15 minutes, then proceed with required repair |
|---|---|
| 05105572A | 2018-12-17. Service bulletin. SERVICE BRAKES, AIR:ANTILOCK:WHEEL SPEED SENSOR; SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING. Part Description: Wheel Speed Sensor Issue Description: Before replacing the front wheel speed sensors, please call Gurdial Dhami at cell (226) 346-7919. If you do not receive a return call after 15 minutes, please proceed with repair. |
| 68166534A | 2018-12-17. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM:HORN. Part Description: Horn and Bracket Issue Description: Before ordering or replacing this part please contact Dennis Gauthier at cell (248) 613-9756. If no response is received within 15 minutes, then proceed with required repair.~ |
| 21-042-15 REV-A | 2018-11-19. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN. Flash: Transmission Shift And Drivability Enhancements This bulletin involves reprogramming the Transmission Control Module (TCM) with the latest available software. Customers may experience one of the following: ? Calibration will prevent unintentional engagement of AutoStick (Manual Mode) when shifter is bumped or tapped. ? Poor shift quality or a delayed shifts. |
| 18-063-15 | 2018-11-19. Service bulletin. ENGINE; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Flash: MIL Illumination, Cold Start and Cruise Control Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) Illumination and/or any of the following: ? Cruise Control acceleration feels to fast at low speeds (35 mph / 56 kph). ? Engine is hard to start when cold Upon further investigation, the technician may find Diagnostic Trouble Codes (DTCs): P219A - Bank 1 Air Fuel Ratio Imbalance. P050B - Cold Start Ignition Timing Performance. |
| 23-035-15 | 2018-11-19. Service bulletin. VISIBILITY:SUN/MOON ROOF ASSEMBLY. Sunroof Leak Under High Water Pressure This bulletin involves installing a new sunroof service trough. The customer may describe a water leak at the rear of the sunroof when using a high pressure touchless car wash. |
| 23-002-15 | 2018-11-19. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. Key Code Missing This bulletin involves key codes that are not on file. |
| 07-001-15 | 2018-11-19. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. Coolant Bottle Recovery Hose Improperly Attached Check the tie strap for the coolant bottle recovery hose and replace if required. Coolant bottle recovery hose may not be properly attached. |
| 21-011-15 | 2018-09-24. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; POWER TRAIN. Transmission Fluid Overfill After Repair This bulletin involves inspecting and adjusting the transmission fluid to the correct level. A small number of customers may experience slight reduction in transmission performance after a recent repair. This may be due to an overfill condition after incorrect fill procedures being followed at the time of the repair. |
| 08-025-15 | 2018-09-24. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES; EQUIPMENT:ELECTRICAL. Flash: Auto Lock Feature Inoperative This bulletin involves updating the Cab Compartment Node (CCN) software. The customer may notice that the power door lock will not auto lock when the vehicle starts moving forward. |
| 09-006-16 | 2018-06-18. Service bulletin. EQUIPMENT; ENGINE. 2.0L Or 2.4L Long Block Replacement This bulletin involves replacing the long block due to incorrect machining operation on the cylinder head. The customer may describe the engine is consuming oil. |
| 05-003-14 | 2018-06-18. Service bulletin. SERVICE BRAKES. Low Frequency Moan Noise Heard During First Brake Apply This bulletin involves installing an anti-vibration bracket to the rear brake caliper. A low frequency moan noise is heard during the first brake apply when in reverse, while the vehicle is cold or has been parked for several hours. An audio sound file of the moan noise can be found in DealerCONNECT> TechCONNECT under: Service Info> 05 - Brakes> 05 - Brakes, Base> Diagnosis and Testing. If the low frequency moan noise can be verified, the addition of the anti-vibration bracket may correct the condition. |
| Z5091195A$ | 2018-06-11. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; EQUIPMENT:ELECTRICAL. RES / RHA / REB radio that supports Bluetooth and Hands-Free For issues with Bluetooth, Hands-Free Calling, and/or Voice Commands, DO NOT replace the radio. Diagnose the Hands-Free Module system (also called the Telematics Module). The Telematics Module (and associated components) is the system responsible for these features. A power cycle may be required for the hands-free module for proper diagnosis.~ Please reference; 8T - Navigation/Telecommunication Diagnosis and Testing (DIAGNOSIS AND TESTING - HANDS FREE PHONE) |
| L0003157 | 2018-06-11. Service bulletin. EXTERIOR LIGHTING. Tail Lamp Bulb If the tail lamp bulb (L00003157) on a 2015 or 2016 MK is being replaced for any reason, engineering would like to have the bulb and the entire lamp assembly replaced and returned for analysis. If you have any questions, please contact Brigitte Wicks at cell (248) 202-9869. Also please make sure to send the part to Brigitte's attention when it is returned. Thank you. |
| 05149171A$ | 2018-06-11. Service bulletin. EQUIPMENT:ELECTRICAL. Oxygen Sensor Before replacing the Upstream (1/1) O2 Sensor on a 2.4L MK due to a P0131 fault code, please contact Vijay Thiruvenkatachary at cell (906) 281-8495.~ Before replacing the Left Downstream (2/2) O2 Sensor on a 3.6L JK due to a P0157 fault code, please call Jerry Tomlin at cell (248) 202-5329. ~ Engineering would like determine whether the sensor has been contaminated with oil.~ If no response is received within 15 minutes, then continue with repair. For all other fault codes, please perform the applicable diagnostic routine. |
| 9003696 | 2018-06-11. Service bulletin. STRUCTURE:BODY:DOOR. Door Hinge Assembly Side door hinge noisy. Only replace the door hinge with the integral check device. Do not replace the simple hinge if it is not damaged it is not the source of the noise. Replacing it unnecessary and is an over-repair. |
| 9003694 | 2018-06-11. Service bulletin. ENGINE AND ENGINE COOLING. Oil Pump Assembly If error code P06DD present on any Pentastar V6 application, please inspect oil pump for relief valve failure. See photo attached. If valve is found out of place please call Bob Jackson (248) 944-0466 bob.jackson@fcagroup.com, or Joe Lovell (734) 309-6467 joe.lovell@fcagroup.com before proceeding. If unable to reach after 15 minutes record the following information and proceed with oil pump replacement and hold part for return to FCA via Fastrack system |
| 9003681 | 2018-06-11. Service bulletin. SEAT BELTS. Restraints Information Sheet (I-Sheet) has been added to Star Parts. Print I-Sheet for technician use. |
| 9003687 | 2018-06-11. Service bulletin. SEAT BELTS. Restraints Remove I-Sheet from packaging. Correct information sheet (I-Sheet) has been added to Star Parts. Print I-Sheet for technician use. |
| 68277402A | 2018-06-11. Service bulletin. VEHICLE SPEED CONTROL:CRUISE CONTROL. Adaptive Cruise Control Sensor 1) If you are replacing this part due to the cluster displaying Clean Radar Sensor in Front of Vehicle or DTC C1266 ACC Sensor Blinded, please verify that there is no blockage in front of the sensor. Blockage can occur from mud, ice, snow, front end damage, bracket damage, the sensor not attached to the bracket properly or an aftermarket fascia installed. This fault can occur intermittently in muddy or icy/snowy conditions and is considered normal operation. Under some circumstances, a misaligned sensor can also cause the C1266 DTC, please complete an alignment procedure. No replacement is required.~ 2) If you are replacing this part due to the cluster displaying ?ACC/FCW Unavailable Service Required?, please check the DTC fault codes. This will indicate which module needs to be serviced (TCM, PCM, ESP/ABS, etc). This fault is not due to the ACC Sensor. No sensor replacement is required.~ 3) If you have fault code DTC C125E ACC Sensor Adjustment Required, please verify that the radar sensor is fully seated in the clips and there is no damage (if clips are damaged on a 2013 or earlier vehicle, order P/N 68085813A$, otherwise please replace the module), please verify there is no blockage to the sensor due to mud, ice, snow, front end damage, bracket damage or the sensor not attached to the bracket properly. Perform the Vertical Alignment and the Electronic Horizontal Alignments procedure as stated in the service manual. Please note, if the horizontal alignment procedure will not complete, check the vertical alignment and confirm that the sensor is seated properly. Rerun the horizontal alignment procedure. No sensor replacement is required. **Hints for running Horizontal Alignment procedure: A) Verify speed is between 45 and 75 mph, B) verify the road is relatively straight with signs, poles, guard rails, etc C) Do not tail a vehicle too closely this inhibits the learning procedure |
| RL305553A | 2018-06-11. Service bulletin. POWER TRAIN. 9-spd Transmission: FOR NAFTA Market Only: If you are ordering this transmission please follow all wiTECH pop ups and Warranty Payment Guidelines. If this vehicle contains 1 of the 30 Diagnostic Codes in the 9 Speed Tutorial located on the Service Home Page then please follow the repair steps and submit a Topology report as well as a Vehicle Scan Report with the Warranty Claim.~ |
| 68105583A | 2018-06-11. Service bulletin. ENGINE AND ENGINE COOLING. Pentastar Oil Filter Adapter: Before replacing this part, please call any one of the following people. Engineering is seeking information regarding this part.~ Dye must be used to determine where the leak is coming from before replacing. Also please check the recently updated Service Bulletin Number 09-008-15. ~ First: Nick Morand Cell (248) 410-8078 - Nick.morand@fcagroup.com Second: Bob Jackson Cell (248) 944-0466 - bob.jackson@fcagroup.com Third: Joe Lovell Cell (734 309-6467 - joe.lovell@fcagroup.com If a response is not received within 15 mins, then proceed with the necessary repair.~ |
| 08-112-14 | 2018-06-11. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. Hands Free Feature Inoperative This bulletin involves updating the Hands Free Module (HFM) software. The customer may notice that the hands free feature (Bluetooth) does not work. On further inspection Diagnostic Trouble Code (DTC), U0197 - Lost Communication With Hands Free Phone Module may be found. |
| 05-003-14 REV. A | 2018-06-11. Service bulletin. SERVICE BRAKES. Low Frequency Moan Noise Heard During First Brake Apply This bulletin involves installing an anti-vibration bracket to the rear brake caliper. A low frequency moan noise is heard during the first brake apply when in reverse, while the vehicle is cold or has been parked for several hours.An audio sound file of the moan noise can be found in DealerCONNECT> TechCONNECT under: Service Info> 05 - Brakes> 05 - Brakes, Base> Diagnosis and Testing.If the low frequency moan noise can be verified, the addition of the anti-vibration bracket may correct the condition. |
| 18-070-14 | 2018-06-11. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Flash: MIL Illumination, P219A, P050B And Cold Start Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. Some customers may see erroneous illuminated malfunction indicator lamps (MIL) and have a hard start cold condition. * P219A Bank 1 Air Fuel Ratio Imbalance * P050B Cold Start Ignition Timing Performance |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.