WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Jeep Compass

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

176 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Lighting are shown. Show all

Bulletins, newest first
18044162022-10-24. Service bulletin. PARKING BRAKE; BACK OVER PREVENTION; ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Flash: Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Codes (DTCs) set in the PCM memory: **P0335 - Crankshaft Position Sensor Circuit. P0456 - Evap System Small Leak.** P219A - Bank 1 Air Fuel Ratio Imbalance. P050B - Cold Start Ignition Timing Performance. Other software enhancements included that will address some customers concerns: · **Cruise control acceleration rate may be considered objectionable to some customers if the accel button is held down. · Engine is hard to start at temperatures -29°C (-20°F) for vehicles utilizing E15 fuel only.**
18-070-142022-08-22. Service bulletin. EXTERIOR LIGHTING; ELECTRICAL SYSTEM. Flash: MIL Illumination, P219A, P050B And Cold Start Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. Some customers may see erroneous illuminated malfunction indicator lamps (MIL) and have a hard start cold condition. ? P219A Bank 1 Air Fuel Ratio Imbalance ? P050B Cold Start Ignition Timing Performance
L00031572018-06-11. Service bulletin. EXTERIOR LIGHTING. Tail Lamp Bulb If the tail lamp bulb (L00003157) on a 2015 or 2016 MK is being replaced for any reason, engineering would like to have the bulb and the entire lamp assembly replaced and returned for analysis. If you have any questions, please contact Brigitte Wicks at cell (248) 202-9869. Also please make sure to send the part to Brigitte's attention when it is returned. Thank you.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.