Recalls that may apply to the 1990 Jeep Cherokee
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 1998012 | 1998-01-23. Brakes. NOTE: VEHICLES ORIGINALLY RETAILED IN ONTARIO, QUEBEC AND THE MARITIME PROVINCES. THE COMPOSITE FRONT DISC BRAKE ROTORS ON THESE VEHICLES MAY FAIL DUE TO CORROSION. THE CAST IRON WEAR SURFACE MAY SEPARATE FROM THE HUB REDUCING THE BRAKING EFFECTIVENESS OF THE VEHICLE. CORRECTION: FRONT COMPOSITE ROTORS WILL BE REPLACED WITH ONES HAVING A REVISED CORROSION PROTECTION COATING. |
|---|---|
| 1996179 | 1996-11-12. Brakes. Vehicles with ABS brakes may experience premature actuator piston seal wear in the ABS hydraulic control unit and/or actuator pump motor deterioration. If this occurs, the abs function may be lost and reduced power assist may be experienced during vehicle braking. Correction: Vehicles with ABS malfunction will be repaired as necessary. Warranty on all abs components will be extended to 10 years or 160,000 km (except for the brake actuator piston assembly and the pump-motor assembly which will have lifetime coverage). |
| 1991109 | 1991-07-24. Brakes. ON VEHICLES WITH ANTI-LOCK BRAKES (ABS), IMPROPER INSERTION/CRIMPING OF THE ABS HIGH PRESSURE HOSE AND FITTINGS COULD RESULT IN HYDRAULIC FLUID LEAKAGE. THIS IN TURN COULD RESULT IN A LOSS OF ASSIST FOR THE BRAKE SYSTEM AS WELL AS A POTENTIAL FOR AN ENGINE COMPARTMENT FIRE. CORRECTION: THE ABS HIGH PRESSURE HOSE WILL BE REPLACED WITH A PROPERLY MANUFACTURED HOSE. |
| 1991007 | 1991-01-09. Brakes. ON VEHICLES EQUIPPED WITH THE ANTI-LOCK BRAKE SYSTEM (ABS), MATERIALS USED IN THE MANUFACTURE AND INSTALLATION OF THE ABS LOW PRESSURE HOSE MAY CONTAMINATE THE BRAKE FLUID IN TWO DIFFERENT WAYS AND IMPAIR THE PROPER FUNCTIONING OF THE ABS SYSTEM. ONE FORM OF CONTAMINATION COULD RESULT IN PLUGGING OF THE ABS BOOSTER PUMP FILTER RESULTING IN LOSS OF ABS FUNCTION. THE OTHER COULD CAUSE STRESS CORROSION FAILURE OF A MASTER CYLINDER SNAP RING RESULTING IN BRAKE DRAG. CORRECTION: ABS LOW PRESSURE HOSE WILL BE REPLACED WITH ONE HAVING A DIFFERENT MATERIAL AND THE MASTER CYLINDER WILL BE REBUILT WITH A NEW PISTON ASSEMBLY CONTAINING A THICKER SNAP RING. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.