Recalls that may apply to the 2008 International 9400i
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 09V386000 | 2009-10-05. ENGINE AND ENGINE COOLING. NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2003 THROUGH 2008 HEAVY TRUCKS MANUFACTURED BETWEEN APRIL 1, 2003 AND DECEMBER 21, 2007, EQUIPPED WITH CATERPILLAR C15 ENGINES. THE VARIABLE VALVE ACTUATION (VVA) OIL LINE MAY WEAR AGAINST THE P-CLIPS RETAINING THE OIL LINE, CAUSING AN OIL LEAK. Built 2003-04-01 to 2007-12-21. |
|---|---|
| 07V180000 | 2007-04-24. FUEL SYSTEM, DIESEL. ON CERTAIN TRUCKS EQUIPPED WITH DAVCO FUEL PRO 382 HEATED FUEL FILTERS, WHEN THE KEY IS IN THE 'ON' POSITION, THE PRE-HEATER, LOCATED IN THE FUEL FILTER BASE, IS ENERGIZED. |
| 07V179000 | 2007-04-24. SUSPENSION:REAR:AXLE:NON-POWERED AXLE ASSEMBLY. ON CERTAIN TRUCKS, ONE OR BOTH REAR AXLE HOUSINGS MAY CONTAIN THINNER MATERIAL THAN WHAT IS NECESSARY FOR NORMAL VEHICLE OPERATION. OVER TIME, THIS THINNER MATERIAL MAY RESULT IN A FATIGUE FAILURE OF THE REAR AXLE HOUSING, POSSIBLY IN THE LOCATION OF THE BRAKE FLANGE. Built 2006-11-15 to 2007-02-19. |
| 2007125 | 2007-04-20. Other. On certain trucks, the rear drive axle housing was manufactured with steel below the specified thickness, which could result in fatigue failure over time. If failure occurs, the outboard end of the housing could eventually separate, allowing the hub, axle shaft, and/or wheel and brake assembly to separate from the vehicle. This could cause a vehicle crash with injury or death. Correction: Dealers will inspect and, if required, replace the axle assembly. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.