Recalls that may apply to the 1998 International 9400
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Suspension are shown.
| None found. |
| 1999204 | 1999-11-10. Suspension. On certain vehicles, the front hubs may have less than an infinite fatigue life if used with a thin brake drum. If a wheel hub experiences fatigue failure the result could be complete wheel separation from the vehicle. This could in turn cause loss of vehicle control and a crash without prior warning. Correction: Both front wheel hubs will be replaced on affected vehicles. |
|---|---|
| 1999052 | 1999-03-31. Suspension. On certain vehicles, the radius on the cone of the inner wheel bearing was incorrectly machined resulting in improper seating of the cone against the seal flange of the steering knuckle. Improper seating of the bearing can increase the stress level on the steer axle knuckle spindle as well as bearing movement and excessive bearing end play. This can result in premature bearing wear, eventual fatigue failure of the axle spindle and loss of steering control. Correction: Inner wheel bearings will be inspected for proper seating and bearings that do not seat properly will be changed. The axle spindle and bearing cup will also be inspected for any damage and will be changed as required. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.