Recalls that may apply to the 2001 International 9300
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| None found. |
| 2004074 | 2004-02-26. Electrical. On certain vehicles, water intrusion into the sleeper berth's bunk control panel area may pool in the tops of the dome light, TV/VCR, and/or refrigerator power switches. The LED circuit boards in these switches may begin to heat up and possibly produce a flame or fire, without warning, that could cause property damage, personal injury, or death. Correction: Dealer will install a water shield over the back of the entire bunk control panel. |
|---|---|
| 2004049 | 2004-02-05. Other. On certain vehicles, a defect in the front wheel hub bearings will result in premature spalling which will lead to eventual breakdown of the bearing. An early breakdown of the wheel hub bearing system, when undetected, can possibly cause a wheel fire, wheel separation, loss of vehicle control, or vehicle fire. Correction: Dealer will inspect the front axle hubs, and replace if necessary. This is an expansion of Recall 03-134. |
| 2003134 | 2003-05-20. Other. On certain vehicles, a defect in the front wheel hub bearings will result in premature spalling which will lead to eventual breakdown of the bearing. An early breakdown of the wheel hub bearing system, when undetected, can possibly cause a wheel fire, wheel separation, loss of vehicle control, or vehicle fire. Correction: Dealer will replace front axle hubs. |
| 2001179 | 2001-07-09. Wheels. Certain buses equipped with 295/75R22.5 tires mounted on 7.5 inch wide wheels, fail to comply with requirements of CMVSS 120, "tire selection and rims for motor vehicles other than passenger cars." these tires and rims do not match. Correction: Dealers will replace the wheels with 8.25" wide wheels. |
| 2001124 | 2001-01-29. Brakes. On certain vehicles, the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters. If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash. Correction: Dealers will install a new bracket on each suspect slack adjuster. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.