Recalls that may apply to the 1997 International 9300
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 2001124 | 2001-01-29. Brakes. On certain vehicles, the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters. If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash. Correction: Dealers will install a new bracket on each suspect slack adjuster. |
|---|---|
| 1997138 | 1997-08-14. Brakes. THE WIRING FROM THE ELECTRONIC CONTROL UNIT MAY HAVE BEEN CONNECTED TO THE WRONG WHEEL SENSOR. SHOULD THE ABS WIRING BE CROSSED, IT WOULD RESULT IN A SIGNIFICANT DEGRADATION IN BRAKE STABILITY. A SIGNAL WOULD BE SENT TO THE WRONG BRAKE CHAMBER WHEN A BRAKE IMBALANCE IS DETECTED. THIS COULD RESULT IN A VEHICLE ACCIDENT WITHOUT PRIOR WARNING. CORRECTION: THE ABS WIRING WILL BE INSPECTED AND PROPERLY CONNECTED AS REQUIRED. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.