Recalls that may apply to the 1996 International 9200
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Suspension are shown.
| None found. |
| 1999204 | 1999-11-10. Suspension. On certain vehicles, the front hubs may have less than an infinite fatigue life if used with a thin brake drum. If a wheel hub experiences fatigue failure the result could be complete wheel separation from the vehicle. This could in turn cause loss of vehicle control and a crash without prior warning. Correction: Both front wheel hubs will be replaced on affected vehicles. |
|---|---|
| 1997137 | 1997-08-13. Suspension. MIS-MATCHED PARTS WERE ASSEMBLED ON SOME SIX SPOKE WHEEL ASSEMBLIES WHICH COULD CAUSE HIGH STRESSES IN THE WHEEL STUDS AND POTENTIAL WHEEL STUD FAILURES. THIS COULD RESULT IN WHEEL SEPARATION AND A POSSIBLE ACCIDENT WITHOUT PRIOR WARNING. CORRECTION: CORRECT PARTS COMBINATIONS WILL BE IMPLEMENTED AND OPERATOR INSTRUCTIONS AND VISUAL AIDS WILL BE UPDATED. |
| 1996131 | 1996-09-10. Suspension. NOTE: VEHICLES EQUIPPED WITH NEWAY ANCHORLOK REAR SUSPENSIONS. THE SUSPENSION EQUALIZING BEAM COULD HAVE DEFECTIVE SUSPENSION SHAFTS WHICH COULD FRACTURE INSIDE THE BEAM AND WORK LOOSE FROM THE BEAM. SHOULD THE SHAFT SEPARATE FROM THE BEAM, THE SUSPENSION AIR BAG WOULD DROP TO THE ROADWAY. SHOULD THIS HAPPEN, IT WOULD AFFECT VEHICLE STABILITY AND CONTROL WHICH COULD POSE A HAZARD TO OTHER USERS OF THE ROADWAY AND ADJACENT PROPERTY. CORRECTION: ALL EQUALIZING BEAMS WITH NON-CONFORMING SHAFTS WILL BE REPLACED. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.