Recalls that may apply to the 1997 International 8100
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| None found. |
| 2001124 | 2001-01-29. Brakes. On certain vehicles, the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters. If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash. Correction: Dealers will install a new bracket on each suspect slack adjuster. |
|---|---|
| 1997228 | 1997-12-22. Engine. THE MATERIAL OF THE ACCELERATOR PEDAL ROD IS BRITTLE AND MAY RESULT IN A FATIGUE FAILURE FROM TORSIONAL STRESS. SHOULD THE ACCELERATOR ROD BREAK, THE ENGINE WOULD RETURN TO IDLE. THIS COULD RESULT IN AN INABILITY TO PROPERLY ACCELERATE THE VEHICLE AND COULD RESULT IN AN ACCIDENT WITHOUT PRIOR WARNING. CORRECTION: THE ELECTRONIC ACCELERATOR RODS ON THESE VEHICLES WILL BE REPLACED WITH NEW RODS. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.