Recalls that may apply to the 2008 International 400
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 08V258000 | 2008-06-05. ELECTRICAL SYSTEM. NAVISTAR IS RECALLING 51,588 HEAVY TRUCKS, COMMERCIAL BUSES AND SCHOOL BUSES MANUFACTURED BETWEEN NOVEMBER 21, 2000 AND MAY 21, 2008, EQUIPPED WITH ONE OR MORE REMOTE POWER MODULES. THE POTTING MATERIAL THAT ENCAPSULATES THE CIRCUIT BOARD OF THE VEHICLE'S REMOTE POWER MODULE MAY NOT SUFFICIENTLY SEAL THE CIRCUIT BOARD FROM WATER AND CONTAMINATION INTRUSION. IF THE ENCAPSULATION IS COMPROMISED, WATER AND CONTAMINANTS MAY CAUSE AN INTERNAL ELECTRICAL SHORT, POSSIBLY RESULTING IN A FIRE. Built 2000-11-21 to 2008-05-21. |
|---|---|
| 08V146000 | 2008-03-26. SUSPENSION:FRONT:WHEEL BEARING. INTERNATIONAL IS RECALLING 330 MY 2008-2009 4000 SERIES TRUCKS AND 3000 RE, FBC, AND SFC BUSES. A MANUFACTURING DEFECT IN THE SUBASSEMBLY OF THE FRONT AXLE WHEEL HUBS RESULTED IN THE BEARINGS BEING INADEQUATELY LUBRICATED. THIS CONDITION COULD CAUSE THE FRONT AXLE BEARINGS TO OVERHEAT WHICH CAN RESULT IN BEARING SPALLING, SEIZING, OR RELATED DAMAGE. Built 2007-12-03 to 2008-01-25. |
| 08V097000 | 2008-02-29. PARKING BRAKE:CONVENTIONAL:AIR. INTERNATIONAL IS RECALLING MY 2008-2009 4000, 5000, 7000, 8000, 9000 AND PROSTAR TRACTOR/TRUCKS EQUIPPED WITH BENDIX MV-3 DASH CONTROL VALVES. THE MOLDED VALVE BODY HAS AN INCORRECT CORE PIN IN THE INJECTION MOLD CAUSING THE VALVE BODY TO BE OVERSIZED IN THE DOUBLE CHECK VALVE AREA. THIS CONDITION CAN ALLOW THE RUBBER DOUBLE CHECK VALVE TO BECOME LODGED IN THE BODY OPENING UNDER CERTAIN CIRCUMSTANCES. Built 2008-01-15 to 2008-02-13. |
| 2008196 | 2008-06-05. Electrical. On certain vehicles, the potting material that encapsulates the circuit board of the remote power module may not sufficiently seal the circuit board from water and contamination intrusion. If the encapsulation is compromised, water and contaminants may cause an internal electrical short. An electrical short could cause a fire which can result in property damage, personal injury, or death. Correction: Dealers will install a fused electrical cable in the ground circuit of each suspect vehicle that has one or more remote power module(s). |
|---|---|
| 2008099 | 2008-03-25. Suspension. On certain vehicles, the front wheel bearings may not have received sufficient lubrication during assembly. This could cause the bearings to overheat, which may result in spalling, seizing, and eventual breakdown. Such damage could cause a wheel fire, wheel lockup, or wheel separation, which could result in a loss of vehicle control and a crash. Should a wheel separate from the vehicle, it could pose a danger to nearby motorists or bystanders, which could result in property damage, personal injury, or death. Correction: Dealers will inspect and, if necessary, replace and/or properly lubricate the front axle wheel bearings. |
| 2008071 | 2008-02-28. Brakes. Certain vehicle may have been assembled with an incorrectly manufactured Bendix MV-3 dash control valve. If the double check valve becomes lodged, in the event of a primary reservoir failure, air pressure can leak past the lodged valve, thereby depleting the secondary reservoir, causing a reduced ability for modulating the emergency brakes. Extended stopping distances may result in a vehicle crash, causing property damage, and/or personal injury or death. Correction: Dealers will inspect and, if necessary, replace the dash control valve. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.