WenmarOpen by Wenmar Pro

Service bulletins for the 2017 Infiniti QX60

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

214 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
ITB17-0472017-09-14. Service bulletin. WHEELS; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. 2017 QX60; WHEEL ALIGNMENT AND ICC SENSOR ADJUSTMENT SERVICE INFORMATION SERVICE INFORMATION For Applied Vehicles that are equipped with the Intelligent Cruise Control (ICC) system: - If the rear toe has been adjusted during a wheel alignment, the ICC sensor does not need to be aligned/adjusted. - The FSU (Front Suspension) and RSU (Rear Suspension) sections of the Electronic Service Manual (ESM) incorrectly states that the ICC sensor needs to be adjusted after adjusting rear toe. - 4 wheel alignment is not required before alignment/adjustment of the ICC sensor. - The CCS (Cruise Control System) section of the ESM incorrectly states that 4 wheel alignment is required before the ICC sensor is aligned/adjusted. NOTE: The ESM will be updated with this information at a later date.
ITB17-0462017-09-14. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. DTC P0036 DIAGNOSTIC INFORMATION SERVICE INFORMATION The Electronic Service Manual (ESM) information for DTC P0036 may be inaccurate or incomplete for the Applied Vehicles. If an Applied Vehicle stores a DTC P0036, follow diagnostic procedures in the ESM for Bank 2 A/F Sensor Heater open or shorted.
ITB17-042a2017-09-14. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:GAS RECIRCULATION VALVE (EGR VALVE). INFINITI; DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. The APPLIED VEHICLES and CLAIMS INFORMATION sections have been revised. No other changes have been made. Please discard previous versions of this bulletin.
ITB17-002b2017-09-14. Service bulletin. ENGINE. INFINITI; OIL LEAKING AROUND VALVE TIMING CONTROL SOLENOID VALVE This bulletin has been amended. The PARTS INFORMATION section has been revised. No other changes have been made. Please discard previous versions of this bulletin.
ITB17-0312017-08-01. Service bulletin. WHEELS; SUSPENSION. 2016-2017 QX60 AND QX60 HYBRID; REVISED WHEEL ALIGNMENT SPECIFICATIONS SERVICE INFORMATION For the Applied Vehicles, some wheel alignment specifications listed in the Front Suspension (FSU) and Rear Suspension (RSU) sections of the Electronic Service Manual (ESM) have been revised. Updated ESMs will be distributed to the field as quickly as possible. Until the updated ESMs are made available, please use the corrected specifications listed in this bulletin.
ITB17-002a2017-08-01. Service bulletin. ENGINE. INFINITI; OIL LEAKING AROUND VALVE TIMING CONTROL SOLENOID VALVE This bulletin does not apply to hybrid vehicles. This bulletin has been amended. The Title has been changed. The PARTS INFORMATION and CLAIMS INFORMATION sections have been amended. Discard previous versions of this bulletin.
ITB15-010c2017-08-01. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. INFINITI; PROCEDURE TO CLEAN CVT TRANSMISSION FLUID COOLERS This bulletin has been amended. The APPLIED VEHICLES section has been revised. Please discard previous versions of this bulletin.
ITB13-055b2017-08-01. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). CVT / TCM CALIBRATION DATA "WRITE" PROCEDURE This bulletin has been amended. APPLIED VEHICLES has been updated. SERVICE INFORMATION has been amended. A REPAIR TABLE has been added. Procedural steps have been added to SERVICE PROCEDURE. Discard all previous versions of this bulletin.
ITB17-0262017-08-01. Service bulletin. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY. INFINITI; FUEL TANK IS SLOW OR DIFFICULT TO FILL IF YOU CONFIRM The fuel tank is slow or difficult to fill (filling nozzle shuts off before tank is full). IMPORTANT: Make sure this incident has been duplicated at a gas station by dealer service staff. ACTION Perform the Service Procedure in this bulletin, starting on the next page.
ITB16-035a2017-08-01. Service bulletin. ENGINE. 2015-2017 QX60; ENHANCED DIAGNOSTIC LOGIC FOR CVT This bulletin applies only to vehicles equipped with a 6 cylinder engine. This bulletin has been amended to add 2017 model year and add part numbers to Table A. No other changes have been made. Please discard all previous versions of this bulletin.
ITB15-012g2017-08-01. Service bulletin. ENGINE. 2013 JX35 AND 2014 - 2017 QX60; CVT JUDDER AND DTC P17F0 OR P17F1 STORED This bulletin applies only to vehciles equipped with a 6 cylinder engine. This bulletin has been amended to add model years to the Applied Vehicles and change the parts information. No other changes have been made. Please discard all previous versions of this bulletin.
ITB17-0022017-08-01. Service bulletin. ENGINE. INFINITI; OIL LEAKING AROUND TIMING CONTROL SOLENOID VALVE This bulletin does not apply to hybrid vehicles. IF YOU CONFIRM Engine oil is leaking from a valve timing control solenoid valve. And The valve timing control solenoid valve operates correctly and is not externally damaged, ACTION Replace the valve timing control solenoid valve O-ring with a new one using the Service Procedure starting on page 2.
ITB17-0012017-08-01. Service bulletin. POWER TRAIN. 2014 - 2017 QX60; FLUID LEAK CAUSED BY TRANSFER ASSEMBLY RIGHT SIDE DRIVE SHAFT SEAL This bulletin applies only to AWD equipped vehicles. IF YOU CONFIRM Fluid is leaking from the right side of the transfer assembly (see Figure 1). NOTE: The fluid leak is not caused by the seal shown in Figure 1. ACTION 1. DO NOT REPLACE the transfer assembly. 2. Reseal the transfer assembly. - Refer to the Electronic Service Manual (ESM), section DLN ? Driveline, for transfer assembly removal, reseal, and installation information. - Refer to page 2 and 3 for additional information. CAUTION: Be careful not to damage the transfer assembly right side drive shaft seal when reinstalling the drive shaft.
ITB12-076c2017-08-01. Service bulletin. STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS; STRUCTURE:BODY:DOOR. POWER BACK DOOR CALIBRATION This bulletin has been amended. Step 15 has been revised. No other changes have been made. Please discard previous versions of this bulletin.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.