WenmarOpen by Wenmar Pro

Service bulletins for the 2008 Hummer H2

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

944 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Automatic transmission are shown. Show all

Bulletins, newest first
16-NA-1302023-03-08. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT:VALVES/VALVE BODY. This service bulletin provides information for after installation of a replacement upper valve body, the transmission may have no Reverse and no 2nd gear.
06-00-89-031D2021-09-07. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
06-00-89-031D2021-04-20. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. OEM and Remanufactured Engine and Automatic Transmission/Transaxle Identification
150089004C2021-03-08. Service bulletin. SUSPENSION:FRONT:MACPHERSON STRUT; SUSPENSION:FRONT:SHOCK ABSORBER; POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. This service bulletin provides technicians with updated information to help identify the differences between what is considered a fluid leak, and what is considered fluid seepage.
1308116001F2020-12-07. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION. The intent of this technical bulletin is to identify aftermarket ALDL or DLC interface devices as potential sources for causing multiple customer concerns that do not have other diagnostic methods to identify them.
PIP3366C2018-08-20. Service bulletin. POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE); POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary information communicates to the dealer technician thatLight Duty Trucks equipped with automatic transmissions and 4 wheel drive may exhibit a condition of grinding/ratcheting type noise when shifting the automatic transmission into park while the transfer case is in 4 wheel drive low (4LO) range. Dealers technician's are advised this condition should be deemed a normal characteristic of 4WD low operation.
09-07-30-018D2018-06-04. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT. This informational bulletin provides a revision for 09-07-30-018C to add the 2014 model year and update the Labor Operation.
PI0938A2018-05-21. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION. This preliminary bulletin provides information on what labor operation number to use for various electrical/electronic control issues.
01-07-30-042H2018-05-21. Service bulletin. POWER TRAIN:CLUTCH ASSEMBLY; POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER; POWER TRAIN. This information was created to inform the technician that the 2-3 upshift and the 3-2 downshift clunk is caused by the releasing of the 2-4 band and application of the 3-4 clutch assembly during an upshift. Also during a 3-2 downshift, the releasing of the 3-4 clutch during the application of the 2-4 band, can cause torque reversal down the output shaft creating a clunk. This is a normal condition.
1203100022017-12-22. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This informational bulletin provides a description of the proper wheel installation and proper wheel torque techniques used to install wheels onto vehicles
PIP4653E2017-12-22. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); POWER TRAIN. This Preliminary Information communication provides information to the technician about vehicle that have a Malfunction Indicator Lamp on. Technician may find Diagnostic Trouble Codes P0601, P0603, P0604, P062F or P1621 stored in the Transmission Control Module. Technician will need to ensure that the Diagnostic Trouble Codes are set in the Transmission Control Module. If the Diagnostic Trouble Codes are only set in the Transmission Control Module reprogram the Transmission Control Module.
09-07-30-018C2017-10-12. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. This warranty administration bulletin provides information on the change in automatic transmission add conditions documentation and claim submissions
02-07-30-052J2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION:COOLING UNIT AND LINES. This informational bulletin provides technicians with information regarding automatic transmission oil cooler flow test essential tool J-45096 TransFlow®.
PIP4765A2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have Service Engine Soon Malfunction Indicator Lamp on and a constant engine misfire. If Service Information diagnosis isolates no compression on the misfiring cylinder(s) with 100% leakage into the crankcase, perform the following steps as necessary before disassembling the engine. Technician will use a lighted bore scope if available to inspect the top of the related piston(s) through the spark plug hole to determine if any of the pistons are melted. If damaged piston(s) are found inspect for aftermarket parts. Also use the latest version of 09-06-04-026 to verify if there are aftermarket calibrations in the Engine Control Module. Take photos and document accordingly if anything is found.
PIP4112N2017-08-15. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle. This is considered normal operation of the vehicle the throttle is delayed and opened slowly up to .7 seconds to help minimize driveline lash and clunking or will have approximately .5 seconds of zero torque to allow the transmission to shift to first gear.
SB-16-NA-1302016-08-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; EQUIPMENT. THIS INFORMATIONAL BULLETIN PROVIDES INFORMATION ON HOW TO INSPECT THE UPPER VALVE BODY TO DETERMINE THE CORRECT RPO USAGE TO CORRECT A CONCERN THAT AFTER INSTALLATION OF A REPLACEMENT UPPER VALVE BODY, THE TRANSMISSION MAY HAVE NO REVERSE AND NO 2ND GEAR DUE TO THE INSTALLATION OF THE INCORRECT UPPER VALVE BODY.
PI-07732014-07-19. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. CADILLAC/CHEVROLET/GMC/HUMMER/PONTIAC: THERE IS SLIPPING OR HAVE NO FOURTH, FIFTH OR SIXTH GEAR AND MALFUNCTION INDICATOR LAMP (MIL) WOULD BE ON, WITH DIAGNOSTIC TROUBLE CODE (DTC) P0796 FOUND AS ACTIVE. *PE
09-07-30-004F2012-04-30. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. GM: SLIPS IN REVERSE OR THIRD, DELAYED REVERSE OR DRIVE ENGAGEMENT, DTC P0776, P2715, P2723, HARSH 2-3 SHIFTS (INSPECT 1-2-3-/ 3-5-R HOUSING AND PUMP SEAL RINGS). THIS CONDITION MAY BE CAUSED BY A CRACKED 1-2-3-4/ 3-5-R CLUTCH HOUSING. *JS UPDATED 5/10/12. *PE UPDATED 04/15/2014 *JS
08-07-30-021G2012-04-28. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). GM: LOSS OF HIGH SPEED GMLAN COMMUNICATIONS, INTERMITTENT NO CRANK, IP GAGE FLUCTUATION, INTERMITTENT DOOR LOOK CYCLING, INTERMITTENT CHIME OPERATION, VARIOUS IP WARNING LAMPS ILLUMINATED, TRANSMISSION MAY NOT SHIFT, COMMUNICATION DTCS U0073, U0100, U0101, U0102 U0121 OR U0140 SET (REPAIR TERMINALS IN TRANSMISSION HARNESS CONNECTOR, REPAIR OPEN OR SHORTED GM HIGH SPEED LAN CIRCUITS, OPEN OR SHORTED DATA LINK RESISTOR, CORROSION OR POOR CONNECTIONS IN VARIOUS CONTROL MODULE CONNECTORS). *JS
SB-07-06-04-019A2009-06-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ENGINE AND ENGINE COOLING:ENGINE. GENERAL MOTORS: INTERMITTENT MIL/SES/ DTC P2138 WITH REDUCED ENGINE POWER (REPAIR INSTRUMENT PANEL (IP) TO BODY HARNESS CONNECTOR). 2005-08 GM PASSENGERS CARS/LIGHT DUTY TRUCKS (INCL. SATURNS). *PE UPDATED 11/5/10. *PE UPDATED 4/4/11. *PE UPDATED 2/3/16. *PE
PIP-43952008-10-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. GMC: FLARE AND OR HARSH 2-3 SHIFTS. THIS CONDITION MAY BE CAUSED BY LEAKING 1-2-3-4 AND 3-5-R CLUTCH FLUID SEAL RINGS (230). MODELS CADILLACS, CHEVROLETS, GMC, HUMMERS, PONTIACS. EQUIPPED WITH 6L80 (RPO MYC) OR 6L90 (RPO MYD) AUTOMATIC TRANSMISSION. *PE
08-08-49-010A2008-09-24. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; LATCHES/LOCKS/LINKAGES:DOORS:LATCH; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. GMC: LOSS OF HIGH SPEED GMLAN COMMUNICATIONS, IPC WARNING LIGHTS ON, DIC MESSAGES, NO CRANK, IPC GAUGE DROP OR FLUCTUATION, DOOR LOCK CYCLING , HARD TRANSMISSION SHIFT, DTCS U0073, U0100, U0101, U0102, U0109, U0121, U0132, U0140, U2100 SET (INSPECT IDENTIFIED ELECTRICAL CONNECTIONS AND WIRING FOR FAULTS). *PE
08-07-30-0232008-08-28. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. 4L60-E/4L65-E/4L70-E AUTOMATIC TRANSMISSION FLUID LEAK FROM OIL PUMP OR BELL HOUSING AREA (REPLACE TORQUE CONVERTER HUB-TO-OIL PUMP SEAL ASSEMBLY). ATTN: THIS BULLETIN APPLIES TO VEHICLES BUILT PRIOR TO DECEMBER 2007. *PE
080802008-05-01. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). SERVICE UPDATE FOR INVENTORY VEHICLES ONLY - TRANSMISSION CONTROL MODULE REPROGRAM (LOW SPEED ENGINE BRAKING SENSATION UPON AUTOMATIC DOWNSHIFT TO FIRST GEAR) - EXPIRES MARCH 31, 2009. *NJ
PIT45502008-05-01. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). LOSS OF HIGH SPEED LAN COMMUNICATIONS. *NJ

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.