WenmarOpen by Wenmar Pro

Recalls that may apply to the 2003 Honda ST1300

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
05V0100002005-01-24. SERVICE BRAKES, HYDRAULIC. CERTAIN MOTORCYCLES EQUIPPED WITH COMBINED-BRAKE SYSTEMS HAVE A PROPORTIONING CONTROL VALVE (PCV) THAT MECHANICALLY PROPORTIONS BRAKE FORCE WHEN THE REAR BRAKE IS APPLIED. A SEAL IN SOME PCVS IS IMPROPERLY SHAPED, AND BRAKE FLUID LEAKAGE MAY OCCUR. Built 2002-03-15 to 2003-09-19.
04V5680002004-12-09. ELECTRICAL SYSTEM:WIRING. ON CERTAIN MOTORCYCLES, THE MAIN WIRE HARNESS HAS A GROUND DISTRIBUTION CONNECTOR THAT IS INCORRECTLY ASSEMBLED. SOME ELECTRICAL CIRCUITS MAY OVERHEAT AND SHORT, INCLUDING THE FUEL PUMP. Built 2002-01-15 to 2003-08-01.
04V5490002004-11-23. ELECTRICAL SYSTEM:WIRING. ON CERTAIN MOTORCYCLES, THE ROUTING OF SOME WIRE HARNESSES MAY ALLOW A CONNECTOR TO CONTACT AND CHAFE AGAINST THE FUEL TANK. Built 2002-01-15 to 2003-08-01.
Canada: Transport Canada, as of 2026-10-19
20050162005-01-24. Brakes. On certain motorcycles, an improperly shaped seal in the brake proportioning control valve could allow brake fluid leakage to occur. With continued use, a leak in the proportioning valve would cause the rear brake to eventually become inoperative. Although the front brake provides most of the braking function, a loss of rear brake force could increase the risk of a crash. Correction: Dealers will replace the brake proportioning valve.
20044332004-12-10. Electrical. On certain motorcycles, the distributor connector cap of the main wire harness was improperly wired, causing one ground circuit to be apportioned an excessive load. If the connector overheats, the power to various circuits could be lost. As a result, a loss of critical lighting or engine power could occur without warning, which could cause a crash. Correction: Dealers will inspect the ground distribution connector and check for damage. If any damage is found, the dealer will install an improved main harness. If no damage is found, the dealer will install a reconfigured connector cap that will apportion the ground load correctly.
20044072004-11-22. Electrical. On certain motorcycles, the routing of some wire harnesses may allow a connector to contact and chafe against the fuel tank. Eventually, the chaffing may cause a short circuit and blow an ignition system fuse. The engine will then stall without warning, which could cause a crash. Correction: Dealers will inspect and reposition the wire harness connector.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.