Recalls that may apply to the 1988 Honda Prelude
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Engine are shown.
| None found. |
| 1989085 | 1989-06-12. Engine. On certain vehicles, the accelerator pedal stopper may be bent when excessive downward force is applied after the pedal has contacted the stopper. In the worst case, the edge of the pedal can be caught and held down by the bent stopper. This could result in loss of vehicle control and a crash without prior warning. Correction: A support will be installed to prevent the stopper from bending. |
|---|---|
| 1987080 | 1987-08-05. Engine. On certain Prelude SI vehicles, throttle body castings may contain slight porosity. During vehicle usage, coolant seepage may occur and eventually residue may accumulate on the throttle valve. The residue could cause the throttle valve to return slowly from the slightly open position to the idle position when the accelerator pedal is released. Correction: The throttle body assembly will be replaced. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.