Recalls that may apply to the 2007 Honda Odyssey
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 2013381 | 2013-11-04. Brakes. On certain vehicles, due to a defect in the Vehicle Stability Assist (VSA) system, the brakes may apply unexpectedly while the vehicle is being driven without the driver pressing on the brake pedal. If this were to occur, the brake lamps would also fail to illuminate. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will affect repairs. |
|---|---|
| 2010364 | 2010-10-22. Brakes. On certain vehicles, a seal in the brake master cylinder may be susceptible to damage which can result in a leak if certain conditions exist. The polymer content affects the amount of lubrication the brake fluid provides to brake system components that are exposed to brake fluid. If the brake fluid is replaced with a low polymer brake fluid, and the brake fluid is subsequently subjected to a manual brake fluid bleeding procedure, as opposed to an automated brake bleed procedure, it is possible for the seal at the end of the brake master cylinder primary circuit to become twisted within its retention groove. If this seal becomes twisted, it can result in a leak of a small amount of brake fluid each time the brake pedal is applied. Should a leak occur, after some time the driver will be alerted by the illumination of the low brake fluid indicator light on the meter panel before any effect on braking performance results. If the driver continues to drive the vehicle without refilling the brake fluid reservoir, the vehicle will eventually exhibit a soft or spongy brake pedal feel, requiring more stroke to achieve equivalent braking force. Eventually, if this continues un-remedied, braking performance will be affected, and will finally result in a low pedal and a loss of one braking circuit. Correction: Dealers will replace the brake master cylinder seal cup and the master power assembly if brake fluid has leaked. |
| 2010079 | 2010-03-16. Brakes. On certain vehicles, during the self-check process that occurs shortly after each time the engine is started, the self-diagnostic software for the Vehicle Stability Assist (VSA) brake modulator causes a condition that can allow air to enter the modulator pump. Over time, and after starting the engine numerous times, it is possible for enough air to enter the system to change the brake pedal feel and affect braking performance. Reduced braking performance could lead to a crash causing property damage, personal injury or death. Correction: Dealers will remove existing air in the brake system then apply sealant and caps to the VSA modulator to prevent air from entering the brake system. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.