Recalls that may apply to the 1991 Honda Accord
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 95V103001 | 1995-05-24. SEAT BELTS:FRONT:BUCKLE ASSEMBLY. THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY. Built 1986-01-01 to 1991-03-01. |
|---|---|
| 93V056000 | 1993-04-22. SEAT BELTS:FRONT:ANCHORAGE. THE REAR OUTSIDE SEATING POSITION SAFETY BELTS MAY LOCK UP AT ANGLES OTHER THAN THOSE REQUIRED BY FMVSS 209, "SEAT BELT ASSEMBLIES". THIS DOES NOT CONFORM TO THE MOTOR VEHICLE SAFETY STANDARD. Built 1989-06-01 to 1992-11-01. |
| 91V195000 | 1991-11-08. INTERIOR LIGHTING. A WASHER IN THE CARGO AREA LIGHT MAY NOT BE PROPERLY ATTACHED, AND MAY HAVE FALLEN IN THE CARGO LIGHT DURING ASSEMBLY. IF THIS OCCURRED, AND THE THREE POSITION LIGHT SWITCH IS IN THE MIDDLE POSITION, AND THE TAILGATE IS OPEN, THE WASHER CAN CAUSE A SHORT CIRCUIT IN THE LIGHT. Built 1990-11-01 to 1991-05-01. |
| 1995086 | 1995-05-24. Seats And Restraints. On certain vehicles, the platic front seatbelt release buttons may break allowing plastic pieces to fall into the buckle assembly. If this should happen, a no latch, false latch or failure to unlatch condition could occur creating the risk of personal injury in the event of a crash or sudden stop. Correction: Front seatbelt buckles will be repaired or replaced as necessary. |
|---|---|
| 1993049 | 1993-04-13. Seats And Restraints. Certain Accord wagons fail to comply with the requirements of CMVSS 209 - Seatbelt Assemblies. Rear outboard seatbelts may lock-up when vehicle is parked at an angle. Correction: Rear seatbelt retractor sensors will be replaced. |
| 1991151 | 1991-11-13. Electrical. On certain Accord Wagons, an idadequately attached washer may have fallen inside the cargo area light during vehicle assembly. If this condition exists, and the light's three-position switch is in the middle position with the tailgate open, the washer could cause a short circuit within the light resulting in overheating and a possible fire. Correction: Dealers will remove the washers installed behind the cargo area light and inspect and replace any damaged light assemblies. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.