WenmarOpen by Wenmar Pro

Service bulletins for the 2005 GMC Yukon

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

789 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Suspension are shown. Show all

Bulletins, newest first
PIT4954C2023-12-26. Service bulletin. SUSPENSION. Suspension.
03-00-91-001I2023-11-22. Service bulletin. WHEELS; POWER TRAIN; STEERING; SUSPENSION; ENGINE AND ENGINE COOLING. This service bulletin provides a vibration analysis worksheet the technician can use in conjunction with the appropriate Vibration Analysis-Road testing procedure when diagnosing vibration concerns.
PIT4954C2023-11-20. Service bulletin. SUSPENSION. Suspension.
150089004B2021-04-16. Service bulletin. SUSPENSION:FRONT:SHOCK ABSORBER; SUSPENSION:FRONT:MACPHERSON STRUT; SUSPENSION:REAR:SHOCK ABSORBER. Information Regarding the Differences Between Fluid Leakage and Seepage This bulletin is intended to help identify the differences between what is considered a fluid leak and what is considered seepage. Improper diagnosis may lead to unnecessary component replacement. Use the following information to determine if the condition is normal acceptable seepage or a defective component
PIT3098G2019-04-08. Service bulletin. SUSPENSION. This Preliminary Information communication provides information to the technician about vehicles that have a lean to the left or right. Technician will need to measure fender wheel-opening heights, front and rear, to quantify vehicle lean. Fender wheel-opening heights are related to, but distinct from, trim height. The front wheel-opening height is known as P height, and the rear wheel-opening height is known as R height. Adjust and heights that are out of specification. After all adjustments are done, perform a front-end alignment and check headlight aim.
03-00-91-001G2018-06-04. Service bulletin. SUSPENSION. This informational bulletin provides a vibration analysis worksheet the technician can use in conjunction with the appropriate Vibration Analysis-Road testing procedure, when diagnosing vibration concerns.
PI02003D2018-05-07. Service bulletin. SUSPENSION. This preliminary informational bulletin provides technicians a recommendation for when they are performing a front end alignment and find an alignment dowel pin missing .
050308002F2017-12-22. Service bulletin. SUSPENSION. This informational bulletin was created to aid the technician in diagnosing the difference between a shock or strut that has a fluid residule from a possible external source from a leaking shaft seal.
PIP53382017-08-15. Service bulletin. SUSPENSION; STRUCTURE:FRAME AND MEMBERS. This Preliminary Information communication provides information to the technician about vibration complaints that are one of the most challenging complaints to accurately diagnose and repair. Technician will need to use Pico Oscilloscope Diagnostic Kit to effectively diagnosis vehicles. Technician should drive the vehicle will using the Pico Oscilloscope to record data. After the data is recorded it should be reviewed to determine the root cause of the concern. If a repair attempt made the concern better but not eliminated or had no affect at all, and are requesting assistance from General Motors Technical Assistance Center record another Pico file and save it to the computer. After the new Pico Oscilloscope data has been saved email the data to General Motors Technical Assistance Center in the subject line include ?Vibration? ?Business Associate Code? and the last 8 of the Vehicle Identification Number.
PIT3098E2017-08-15. Service bulletin. STRUCTURE:FRAME AND MEMBERS; SUSPENSION; EXTERIOR LIGHTING:HEADLIGHTS. This Preliminary Information communication provides information to the technician about vehicles that have a lean to the left or right. Technician will need to measure fender wheel-opening heights, front and rear, to quantify vehicle lean. Fender wheel-opening heights are related to, but distinct from, trim height. The front wheel-opening height is known as P height, and the rear wheel-opening height is known as R height. Adjust and heights that are out of specification. After all adjustments are done, perform a front-end alignment and check headlight aim.
PI02003D2017-08-15. Service bulletin. SUSPENSION:FRONT. This preliminary informational bulletin provides technicians a recommendation for when they are performing a front end alignment and find an alignment dowel pin missing .
PIT4954C2017-08-15. Service bulletin. ELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); SUSPENSION. This Preliminary Information communication provides information to the technician about vehicles that have a Service Suspension System message on the Driver Information Center and the rear suspension ride height is incorrect. Technician will find Diagnostic Trouble Code C0696 or C0711 set in Electronic Suspension Control. Technician will need to inspect air compressor assembly for wire damage and repair any damage do not replace the complete air compressor assembly. Some vehicles may have a Service Suspension System message on the Driver Information Center and may also comment that the rear suspension ride height may be low under a heavy payload. Technician will follow published Service Information diagnostics and if determine if the sensor needs to be replaced technician will need to replace a complete air filter, dryer, and sensor assembly. Some vehicles may have a loose hose hanging down in the left rear of the vehicle. Technician will replace the auto leveling compressor air inlet filter and hose assembly. Also some vehicles may have automatic level control compressor is no longer performing a self-test at start up. Be advised the automatic level system normally will not or very infrequently cycle the compressor at key up.
PIT3078F2017-08-15. Service bulletin. WHEELS:HUB; SUSPENSION:FRONT:HUB. This Preliminary Information communication provides information to the technician about vehicles that have grease leaking from front hub bearings. Technician should not replace the bearing for grease purge. Technician should be advised to not clean the purged grease from the area immediately on or adjacent to the seals because this grease provides additional protection. Technician should only replace the bearing if the seals show visible damage, bearing endplay is greater than 0.005" or 0.13mm, bearing exhibits rough rotation, or bearing exhibits abnormal noise.
PIT4954D2017-08-15. Service bulletin. SERVICE BRAKES, AIR:SUPPLY:COMPRESSOR; SUSPENSION. This Preliminary Information communication provides information to the technician about vehicles that have a Service Suspension System message on the Driver Information Center and the rear suspension ride height is incorrect. Technician will find Diagnostic Trouble Code C0696 or C0711 set in Electronic Suspension Control. Technician will need to inspect air compressor assembly for wire damage and repair any damage do not replace the complete air compressor assembly. Some vehicles may have a Service Suspension System message on the Driver Information Center and may also comment that the rear suspension ride height may be low under a heavy payload. Technician will follow published Service Information diagnostics and if determine if the sensor needs to be replaced technician will need to replace a complete air filter, dryer, and sensor assembly. Some vehicles may have a loose hose hanging down in the left rear of the vehicle. Technician will replace the auto leveling compressor air inlet filter and hose assembly. Also some vehicles may have automatic level control compressor is no longer performing a self-test at start up. Be advised the automatic level system normally will not or very infrequently cycle the compressor at key up.
PIT-4954-C2013-08-06. Service bulletin. SUSPENSION. GM: IF THE SERVICE SUSPENSION SYSTEM IS DISPLAYED ON THE DIC, THE TRIM HEIGHT MAY BE INCORRECT, LOOSE COMPRESSOR INLET HOSE, OR THE COMPRESSOR SELF TEST MAY BE INOPERATIVE. ALSO INCLUDED SUBURBAN LD MY 2001-2013, YUKON DENALI XL MY 2013, YUKON XL LD 2001-2013 *JS
PIP4054A2008-04-07. Service bulletin. SUSPENSION:REAR; POWER TRAIN:DRIVELINE:DIFFERENTIAL UNIT. EATON LOCKING DIFFERENTIAL CHATTER SHUDDER NOISE ON TURNS, EQUIPPED WITH A LOCKING REAR DIFFERENTIAL RPO G80. *NJ UPDATED 7/17/2008. *PE
33402007-01-25. Service bulletin. SUSPENSION:FRONT:SPRINGS:LEAF SPRING ASSEMBLY:U-BOLT, LEAF SPRING TO AXLE. LEFT FRONT AXLE SHAFT DIFFICULT TO REMOVE. AXLE DIFFERENTIAL LEAK SEAL SHAFT. *KB
0603080022006-05-05. Service bulletin. SUSPENSION:FRONT:CONTROL ARM:UPPER ARM. REVISED UPPER CONTROL ARM REPLACEMENT. *TT
0403160032005-11-08. Service bulletin. SUSPENSION. TIRE SLOWLY LOSES AIR, LOW TIRE PRESSURE WARNING LIGHT ON, CHECK TIRE PRESSURE MESSAGE DISPLAYED. *TT
35692005-11-02. Service bulletin. SUSPENSION:REAR:AXLE:NON-POWERED AXLE ASSEMBLY. SERVICE VME - 8.6 INCH REAR AXLE WHICH EXHIBIT A GEAR WHINE CONDITION (UNTIL DECEMBER 23, 2005). *TT
35252005-09-28. Service bulletin. SUSPENSION:REAR. AUTOMATIC LEVEL CONTROL INOPERATIVE DUE TO WATER INGESTION. *TT
0203070022005-05-12. Service bulletin. SUSPENSION. REVISED FRONT CASTER AND CAMBER ADJUSTMENT PROCEDURE. ORIGINAL NOT YET RECEIVED. *TT
33792005-05-12. Service bulletin. SUSPENSION. 8.625 AXLE PHASING, GROWL, CYCLIC, NOISE WHILE DRIVING. *TT
040310007D2005-01-11. Service bulletin. SUSPENSION. 20 INCH WHEELS AND TIRES AVAILABLE THROUGH GMSPO. *TT UPDATED. *NM
3000A2004-08-25. Service bulletin. SUSPENSION:REAR. REAR AXLE LOCKING DIFFERENTIAL CHATTER SHUDDER NOISE ON TURNS. *MJ

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.