Recalls that may apply to the 2015 GMC Sierra
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 2019533 | 2019-10-24. Brakes. Issue: On certain vehicles, there may be an error in the electronic-brake control module software. This could cause the driveline-protection system to activate when a wheel-speed sensor fails. If this happens, the brakes could apply and cause the vehicle to pull to one side. Note: This recall only affects vehicles equipped with four-wheel drive, a 5.3-L engine, and a 3.08 ratio rear axle. The problem can only occur when the vehicle is in four-wheel drive or automatic mode, and travelling at a speed between 66 and 97 km/h (41 and 60 mph). A wheel-speed sensor failure will cause the electronic stability control (ESC) and anti-lock braking system (ABS) warning lights to turn on, and a "Service StabiliTrak" message to display. Safety Risk: A vehicle that suddenly pulls to one side could increase the risk of a crash. Corrective Actions: General Motors will notify owners by mail and instruct you to take your vehicle to a dealer to update the electronic-brake control module software. General Motors advises that using two-wheel-drive mode can eliminate the risk until the recall repair is completed. |
|---|---|
| 2019324 | 2019-06-28. Brakes. Issue: On certain vehicles, there could be a reduction in power brake assist due to a decrease in output from the vacuum pump. This could cause a hard brake pedal and an increase in brake pedal effort to stop the vehicle. Safety Risk: A sudden increase in brake pedal force could lead to an increase in stopping distance. This could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their vehicle to a dealer to reprogram the electronic brake control module. |
| 2018464 | 2018-08-31. Brakes. Certain Heavy Duty and Police/Special Service vehicles may not have been repaired properly under Recall 2016-053 (GM #20760). The brake pedal pivot nut may become loose, causing the brake pedal to be loose or inoperative. If this happens, a driver may be unable to safely stop the vehicle or the brake pedal may interfere with the accelerator pedal. Both of these situations could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will add adhesive to the pivot nut and will reinstall it at an increased torque. Note: This condition may result in the "Service Engine Soon" light illuminating, and brake lights may stay on longer than expected. |
| 2016053 | 2016-02-04. Brakes. On certain Heavy Duty and Police Pursuit vehicles, the brake pedal pivot nut may become loose, causing the brake pedal to be loose or inoperative. If the brake pedal becomes loose or inoperative, it could interfere with the accelerator pedal, and/or the driver may be unable to safely stop the vehicle through application of the brake pedal, potentially affecting stopping distances and increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the pivot bolt installation to determine whether the vehicle has already received the production remedy. If not, the dealer will add adhesive to the nut, and reinstall the nut at an increased torque. Note: This condition may result in the "Service Engine Soon" light illuminating, and brake lights may stay on longer than expected. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.