WenmarOpen by Wenmar Pro

Service bulletins for the 2007 GMC Sierra

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1631 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Backup camera are shown. Show all

Bulletins, newest first
15NA082B2024-02-12. Service bulletin. BACK OVER PREVENTION. Clunking Noise from Front of Vehicle During Turns and/or Bumps
15NA0822024-02-12. Service bulletin. BACK OVER PREVENTION. Clunking Noise from Front of Vehicle During Turns and/or Bumps
PIT5039C2023-12-26. Service bulletin. BACK OVER PREVENTION:SOFTWARE; UNKNOWN OR OTHER. Removing / Disabling Rear Park Assist RPO UD7.
080604006N2022-06-13. Service bulletin. POWER TRAIN; FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE; BACK OVER PREVENTION. This informational bulletin provides technicians with Information for Identifying non-GM ECM calibration use and Power-Up hardware detection in Duramax™ diesel engines — Photograph Tech 2® Calibration IDs, Calibration Verification Numbers (CVNs) and Transmission Data Screen.
10-00-89-006C2018-04-16. Service bulletin. BACK OVER PREVENTION: SENSING SYSTEM: RADAR. This informational bulletin provides directions on submitting different PIRs
PIT5209A2017-12-22. Service bulletin. ELECTRICAL SYSTEM; BACK OVER PREVENTION: BACK-UP ALARM; BACK OVER PREVENTION; STRUCTURE. This Preliminary Information communication provides information to the technician about vehicles that for no reason the alarm will go active. Technician will need to use a scan tool to verify that the alarm was activated by the inclination sensor. If the trigger is the inclination sensor, inspect the sensor's mounting location. Technician will need to relocate the sensor if it is attached to the driver's side lower Heater-Vent-Air Conditioning duct. Technician will need to reinstall the sensor to the top of the Body Control Module bracket.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.