Recalls that may apply to the 2000 GMC Sierra
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 2005116 | 2005-04-22. Brakes. On certain 1999-2002 1500 series and 2001-2005 2500 & 3500 series trucks equipped with a manual transmission, the parking brake friction lining may wear to an extent where the parking brake can become ineffective in immobilizing a parked vehicle. Correction: Dealers will install a low-force spring clip retainer on vehicles equipped with PBR parking brake system and install a redesigned parking brake cable assembly on vehicle equipped with a TRW parking brake system. |
|---|---|
| 2005010 | 2005-01-14. Brakes. Certain vehicles are equipped with a hydraulic pump driveshaft that can fracture, resulting in immediate loss of hydraulic power steering assist. On certain vehicles equipped with Hydro-Boost power brakes, the same condition can result in loss of power assist for braking after the reserve pressure is depleted. Correction: Dealers will replace the hydraulic pump. This action is deemed a Customer Satisfaction Campaign and is not being conducted under the Safety Act. |
| 2004395 | 2004-11-05. Brakes. Certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador may experience unwanted Antilock Brake System (ABS) activation and increased stopping distances during low-speed brake application (less than 16 km/h and greater than 6 km/h). This condition does not set any ABS codes nor does it illuminate the ABS warning lamp. Correction: Dealers will remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply Zinc-X to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the output voltage to ensure the wheel speed signal is within specifications. |
| 2000270 | 2000-11-17. Brakes. On certain vehicles, the body cross sill may contact the front, right-hand brake pipe. This could eventually wear a hole in the brake pipe over the normal life of the vehicle and result in a brake fluid leak. This could ultimately result in a partial brake system failure and increased stopping distances. Correction: Dealers will inspect for brake pipe wear and replace worn section if necessary. A spacer clip will be installed to ensure adequate clearance. |
| 2000055 | 2000-03-08. Brakes. Certain vehicles may have an Antilock Braking System (ABS) motor containing an out of specification spring clip which could in time become misaligned. This could cause retainer bearing friction, higher motor current draw and eventually render the ABS non-functional. This would cause the warning lights to illuminate and the Dynamic Rear Proportional (DRP) system to become inoperative. The base brakes would still remain functional and if the operator were to ignore the red brake warning light, the higher rear brake input could cause rear wheel lock up with the possibility of a crash. Correction: Dealers will replace the back pressure module valve assembly. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.