Recalls that may apply to the 1999 GMC B7
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 00V232008 | 2000-09-07. SERVICE BRAKES, AIR:ANTILOCK. VEHICLE DESCRIPTION: SCHOOL BUSES, MEDIUM DUTY TRUCKS AND TRACTORS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL. Built 1998-05-01 to 1999-07-31. |
|---|---|
| 00V236000 | 2000-08-23. POWER TRAIN:AUTOMATIC TRANSMISSION. VEHICLE DESCRIPTION: MEDIUM DUTY TRUCKS. THE TRANSMISSION FLUID COULD LEAK FROM A HEAT DEGRADED TRANSMISSION FLUID COOLER HOSE ONTO THE EXHAUST SYSTEM ON THE PASSENGER'S SIDE OF THE VEHICLE. Built 1998-05-01 to 1999-07-31. |
| 99V320000 | 1999-11-15. POWER TRAIN:AUTOMATIC TRANSMISSION. VEHICLE DESCRIPTION: MEDIUM DUTY CONVENTIONAL CAB TRUCKS AND SCHOOL BUS CHASSIS EQUIPPED WITH AN AUTOMATIC TRANSMISSION, HAVE TRANSMISSION SHIFT CABLE END RODS THAT HAVE NOT BEEN CRIMPED TO THE PROPER SPECIFICATION. OVER TIME, THE SHIFT CABLE COULD BE PULLED OUT OF THE ROD END CAUSING THE DRIVER TO LOSE THE ABILITY TO MANUALLY CHANGE TRANSMISSION GEARS. Built 1999-01-01 to 1999-01-31. |
| 2001140 | 2001-04-19. Steering. Certain heavy duty trucks and school bus chassis equipped with tie rod assemblies containing 24-DL model ball sockets and manufactured by TRW. Certain of the tie rod ball-socket bearings have a below-specification case depth and/or hardness, which can lead to premature wear of the socket. If this condition occurs, the driver can lose partial control of the right front wheel, possibly resulting in a crash. Correction: Dealers will replace the defective ball sockets and/or drag links. |
|---|---|
| 2000182 | 2000-08-30. Other. On certainve vehicles, transmission fluid may leak from a heat degraded transmission fluid cooler hose onto the exhaust system on the passenger's side. If this were to occur, a fire could result. Correction: Dealers will install a new transmission fluid cooler inlet hose and outlet hose designed with a heat sleeve and ensure adequate clearance to the exhaust system take down pipe. The right hand exhaust manifold seal will be inspected for leakage and replaced if necessary. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.