Recalls that may apply to the 1991 Freightliner MB80
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 93V148000 | 1993-09-14. VISIBILITY:WINDSHIELD WIPER/WASHER. THE WINDSHIELD WIPER ARM SUPPORT CRACKS WHERE THE WIPER ARM PIVOT MOUNTS TO THE SUPPORT BRACKETS CAUSING FAILURE OF THE SYSTEM. Built 1991-05-01 to 1992-03-01. |
|---|---|
| 92V057000 | 1992-04-14. SEAT BELTS:FRONT:ANCHORAGE. A NUMBER OF CABS WERE ASSEMBLED WITH FEWER WELDS THAN SPECIFIED IN THE UPPER B PILLAR NEAR THE ANCHORAGE FOR THE SEAT BELT. WELDING MATERIALS USED ON THE INBOARD ANCHORAGE BRACKET UNDER THE CAB DECK WILL NOT MEET FMVSS NO. 210 LOAD TEST REQUIREMENTS WHEN THREE SEATING POSITIONS ARE PROVIDED. Built 1991-05-01 to 1992-07-01. |
| 1993122 | 1993-09-13. Visual System. THE WINDSHIELD WIPER ARM SUPPORT BRACKET MAY CRACK WHERE THE WIPER ARM PIVOT MOUNTS TO THE SUPPORT BRACKET. THIS COULD RESULT IN SUDDEN FAILURE OF THE WINDSHIELD WIPER SYSTEM WITHOUT PRIOR WARNING AND COULD CAUSE IMPAIRED DRIVER VISION IF THE FAILURE WERE TO OCCUR DURING INCLEMENT WEATHER CONDITIONS. CORRECTION: WINDSHIELD WIPER ARM SUPPORT BRACKET WILL BE REPLACED WITH A REDESIGNED SUPPORT BRACKET. |
|---|---|
| 1992062 | 1992-05-26. Seats And Restraints. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 210 - SEAT BELT ASSEMBLY ANCHORAGES. - WELDING MATERIALS USED ON THE INBOARD ANCHORAGE BRACKET UNDER THE CAB DECK WILL NOT MEET THE LOAD TEST REQUIREMENTS OF THE STANDARD WHEN 3 SEATING POSITIONS ARE PROVIDED. CORRECTION: VEHICLES WILL REQUIRE ADDITIONAL REINFORCEMENT IN THE UPPER B PILLAR AND ADDITIONAL FASTENERS IN THE LOWER DECK ANCHORAGE BRACKET. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.