WenmarOpen by Wenmar Pro

Recalls that may apply to the 2007 Freightliner FLD120

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
07V5300002007-11-13. TRAILER HITCHES:FIFTH WHEEL ASSEMBLY. ON CERTAIN TRUCK-TRACTORS EQUIPPED WITH HOLLAND SIMPLEX SE OR SE II FIFTH WHEELS, THE LATCH LEVER PIVOT BOLT ASSEMBLY MAY HAVE BEEN OVER-TIGHTENED WHICH COULD DISTORT THE PIVOT BOLT SPACER SLEEVE. CORROSION OR CONTAMINATES IN THE PIVOT MAY CAUSE IT TO BIND AND PREVENT THE FIFTH WHEEL JAW FROM LATCHING SECURELY AROUND THE TRAILER KING PIN. Built 2006-01-01 to 2007-05-31.
07V3160002007-07-24. SUSPENSION:REAR. ON CERTAIN TRUCKS EQUIPPED WITH TUFTRAC REAR SUSPENSIONS, THE CENTER CASTING BRACKETS MAY BE OUT OF SPECIFICATION. AN OUT OF SQUARE CASTING MAY HAVE UNACCEPTABLE STRESS IN THE BRACKET WHEN IT IS INSTALLED AND MAY CAUSE IT TO CRACK IN SERVICE. Built 2006-11-01 to 2007-11-30.
07V3060002007-07-18. STEERING. FREIGHTLINER IS RECALLING CERTAIN SCHOOL BUS CHASSIS, HEAVY TRUCKS, VAN CHASSIS, RV MOTORHOME CHASSIS MANUFACTURED FROM JANUARY 5 TO MAY 17, 2007, EQUIPPED WITH AXLE ALLIANCE COMPANY (AAC) FRONT AXLES. DURING THE FRONT AXLE ASSEMBLY, THE FASTENERS THAT ATTACH THE STEERING ARM OR TIE ROD ARMS TO THE SPINDLE MAY BE OVER OR UNDER TIGHTENED. Built 2007-01-05 to 2007-05-17.
07V3020002007-07-16. SERVICE BRAKES, AIR:SUPPLY:CHECK VALVE. CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY. Built 2002-07-01 to 2007-07-03.
Canada: Transport Canada, as of 2026-10-19
20072312007-07-11. Brakes. On certain vehicles, the internal rubber check valve inside the Bendix SR-7 spring brake modulating valve can become deformed over time. The effect of this defect is intermittent and presents a potential delay or failure in applying the parking brakes; potentially resulting in a vehicle roll away. Should this occur, the unattended roll away vehicle could strike a bystander or cause property damage. Correction: Dealers will install a check valve repair kit.
20072302007-07-11. Suspension. On certain trucks, the flange, crossmember, and web mounting surfaces of the center suspension mounting bracket casting may not be perpendicular. An out of square casting may have unacceptable stresses in the bracket when it is installed and may cause it to crack in service. The driveline may not be held in position if a cracked bracket fractures completely. This will affect vehicle control and may cause a crash without warning. Correction: Dealers will replace casting out of specs.
20072292007-07-11. Steering. On certain vehicles, the fasteners that attach the steering arm or tie rod arm to the spindle may have been over or under tightened during assembly process. Incorrectly torqued steering arm fasteners may fatigue and fracture, possibly causing a crash without warning. Correction: Dealers will inspect fasteners and apply correct tightening torque.
20071732007-05-31. Other. On certain trucks, the rear drive axle housing was manufactured with steel below the specified thickness, which could result in fatigue failure over time. If failure occurs, the outboard end of the housing could eventually separate, allowing the hub, axle shaft, and/or wheel and brake assembly to separate from the vehicle. This could cause a vehicle crash with injury or death. Correction: Dealers will inspect and, if required, replace the axle assembly.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.