Recalls that may apply to the 2006 Freightliner Columbia
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about SUSPENSION are shown.
| 07V169000 | 2007-04-12. SUSPENSION:FRONT:HUB. ON CERTAIN TRUCKS BUILT WITH FRONT AXLES ASSEMBLED BY ARVINMERITOR, THE FRONT SPINDLE NUT MAY BE OVER-TIGHTENED CAUSING PRELOAD ON THE FRONT WHEEL BEARINGS WHICH COULD LEAD TO PREMATURE BEARING WEAR. Built 2005-06-01 to 2006-12-31. |
|---|---|
| 06V424000 | 2006-11-02. SUSPENSION:FRONT. ON CERTAIN TRUCKS EQUIPPED WITH ARVINMERITOR FRONT AXLE ASSEMBLIES, THE FRONT SPINDLE NUT MAY BE OVER-TIGHTENED CAUSING PRELOAD ON THE FRONT WHEEL BEARINGS WHICH MAY LEAD TO PREMATURE BEARING WEAR. Built 2005-11-01 to 2006-09-30. |
| 2006301 | 2006-11-08. Suspension. On certain trucks, the front spindle nut may have been over-tightened during vehicle assembly, causing preload on the front wheel bearings which may lead to premature bearing wear. If rapid bearing wear is allowed to progress, the front wheel assembly may separate from the vehicle and cause a crash. Correction: Dealers will verify bearing adjustment and, if found to be incorrect, will replace the bearings. |
|---|---|
| 2005381 | 2005-12-02. Suspension. On certain vehicles, a manufacturing defect of the front axle I-beam top flange may result in a reduction of axle service life. The axle I-beam may fatigue and fracture, causing a possible loss of vehicle control and subsequent crash without prior warning. Correction: Dealers will replace the front axle assembly. |
| 2005318 | 2005-10-18. Suspension. On certain vehicles, the rear spindles may fracture as a result of incorrect heat treat process during vehicle assembly. Rear spindle failure could allow the wheel, tire, and brake drum assembly to separate from the vehicle. The wheel end assembly could become a hazard for other traffic. Correction: Dealers will inspect for the heat treat date code on the end of the rear spindles. Axle housings will be replaced on vehicles manufactured with spindles that have the subject date codes. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.