Recalls that may apply to the 1986 Freightliner C.O.E.
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about STRUCTURE are shown.
| 89V090000 | 1989-06-05. STRUCTURE:BODY. CORROSION OF THE GRABHANDLE AT ITS MOUNTING SURFACE MAY LEAD TO CRACKING OR LOSS OF STRENGTH. Built 1979-05-01 to 1987-07-01. |
|---|---|
| 87V091000 | 1987-06-15. STRUCTURE. BUCKLING OF THE TILT CYLINDERS MAY OCCUR WHILE LOWERING THE VEHICLES CAB DUE TO IMPROPER USE OF THE CAB TILT SYSTEM. Built 1985-11-01 to 1987-09-01. |
| 86V118000 | 1986-08-26. STRUCTURE:BODY. THE HANDHOLD MOUNTING SYSTEM, WHICH CONSISTS OF A TUBULAR HANDLE HELD IN THREE PLACES BY CAST ALUMINUM BRACKETS AND ATTACHED TO THE ENGINE EXHAUST MUFFLER HEAT SHIELD. VIBRATION FROM THIS SYSTEM CAUSES THE HANDHOLD PARTS TO WEAR. CONSEQUENCE OF DEFECT: IF THE PARTS WEAR THIN THE POSSIBILITY EXISTS THAT THE HANDHOLD MIGHT GIVE WAY UNDER THE WEIGHT OF A DRIVER. THIS COULD RESULT IN PERSONAL INJURY. Built 1983-09-01 to 1986-07-01. |
| 1987089 | 1987-08-18. Structure. IMPROPER USE OF THE CAB TILT SYSTEM MAY RESULT IN BUCKLING OF THE TILT CYLINDERS. THIS CAN OCCUR IF THE OPERATOR ATTEMPTS TO LOWER THE CAB BY CONTINUED PUMPING DOWN OF THE SYSTEM WITHOUT RELEASING THE SAFETY LATCH OR AFTER A TILT CYLINDER VELOCITY FUSE HAS LOCKED-UP. IF BUCKLING OCCURS, THE CAB MAY DROP TO ITS LOWERED POSITION. CORRECTION: 1 1/2" DIAMETER TILT CYLINDERS WILL BE REPLACED WITH 2" DIAMETER CYLINDERS. |
|---|---|
| 1986113 | 1986-10-08. Structure. THE HANDHOLD MOUNTING SYSTEM CONSISTS OF A TUBULAR HANDLE HELD IN THREE PLACES BY CAST ALUMINUM BRACKETS WHICH ARE, IN TURN, ATTACHED TO THE ENGINE EXHAUST MUFFLER HEAT SHIELD. VIBRATION FROM THE EXHAUST SYSTEM CAUSES THE HANDHOLD PARTS TO WEAR THIN AND COULD CAUSE THE HANDHOLD TO GIVE WAY UNDER THE WEIGHT OF A DRIVER. THIS COULD RESULT IN PERSONAL INJURY. CORRECTION: REPLACE THE HANDHOLD WITH A MODIFIED DESIGN WHICH UTILIZES A RUBBER ISOLATOR. ADD A PLASTIC SLEEVE TO THE CENTER BRACKET FOR ISOLATION. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.