WenmarOpen by Wenmar Pro

Recalls that may apply to the 2005 Freightliner Argosy

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
09V3660002009-09-23. ENGINE AND ENGINE COOLING. DAIMLER TRUCKS IS RECALLING MODEL YEAR 2004-2010 TRUCKS EQUIPPED WITH CATERPILLAR C15 ENGINE. THE VARIABLE VALVE ACTUATION OIL LINE MAY RUB AGAINST THE P-CLIPS RETAINING THE OIL LINE, CAUSING AN OIL LEAK. Built 2003-04-01 to 2009-06-30.
07V3020002007-07-16. SERVICE BRAKES, AIR:SUPPLY:CHECK VALVE. CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY. Built 2002-07-01 to 2007-07-03.
06V1900002006-06-05. ELECTRICAL SYSTEM. ON CERTAIN TRUCKS, THE PROTECTIVE COVER FOR THE CAB POWER DISTRIBUTION MODEL (PDM) MAY BE MISSING OR IMPROPERLY INSTALLED. Built 2004-09-07 to 2005-10-17.
05V4670002005-10-05. SUSPENSION:REAR:AXLE:SPINDLE. CERTAIN 2005 THOMAS BUILT FS-65 AND C-2 SCHOOL BUSES AND 2005 FREIGHTLINER ARGOSY, COLUMBIA, CENTURY ST, AND M2 BUSINESS CLASS TRUCKS MANUFACTURED BETWEEN JUNE 4 AND JULY 8, 2005. THE SPINDLES IN THE REAR AXLE HOUSING WERE OVERHEATED DURING THE HEAT TREATMENT PROCESS. INCORRECTLY HEAT TREATED SPINDLES COULD RESULT IN A FRACTURE OF THE SPINDLE. Built 2005-07-13 to 2005-07-08.
Canada: Transport Canada, as of 2026-10-19
20092702009-09-22. Engine. On certain vehicles equipped with a Caterpillar C15 engine, the Variable Valve Actuation (VVA) oil line may wear against the P-clip retaining the oil line. An oil leak could result in a vehicle fire causing property damage and/or personal injury. Correction: Caterpillar dealers will replace the VVA oil line with an updated version.
20072312007-07-11. Brakes. On certain vehicles, the internal rubber check valve inside the Bendix SR-7 spring brake modulating valve can become deformed over time. The effect of this defect is intermittent and presents a potential delay or failure in applying the parking brakes; potentially resulting in a vehicle roll away. Should this occur, the unattended roll away vehicle could strike a bystander or cause property damage. Correction: Dealers will install a check valve repair kit.
20072152007-06-26. Steering. On certain vehicles, the steering column may have been manufactured incorrectly. Two welds may have been omitted, which could cause the column to fail, possibly leading to a loss of steering control and a crash without warning. Correction: Dealers will inspect and replace columns with missing welds.
20061332006-06-05. Electrical. On certain vehicles, the protective cover for the cab Power Distribution Module (PDM) may be missing or improperly installed. If the protective cover is missing or not positioned correctly, any water intrusion from an open window or windshield leak may seep through the upper dash cover seam and drip onto the PDM. Water on the PDM circuits may cause a short circuit resulting in a fire that could cause personal injury. Correction: Dealers will install an updated protective cover.
20060842006-04-19. Suspension. On certain vehicles, the rear suspension transverse beam castings were not made to specifications. If a casting were to break when the vehicle is in motion, parts could become projectiles with potential to cause property damage, personal injury or death. Also, the transverse beam may drop down low enough to contact the road surface causing sparks that could ignite a fire. Correction: Dealers will inspect and, if necessary, replace the transverse beams.
20053182005-10-18. Suspension. On certain vehicles, the rear spindles may fracture as a result of incorrect heat treat process during vehicle assembly. Rear spindle failure could allow the wheel, tire, and brake drum assembly to separate from the vehicle. The wheel end assembly could become a hazard for other traffic. Correction: Dealers will inspect for the heat treat date code on the end of the rear spindles. Axle housings will be replaced on vehicles manufactured with spindles that have the subject date codes.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.