Recalls that may apply to the 2002 Freightliner Argosy
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| None found. |
| 2007231 | 2007-07-11. Brakes. On certain vehicles, the internal rubber check valve inside the Bendix SR-7 spring brake modulating valve can become deformed over time. The effect of this defect is intermittent and presents a potential delay or failure in applying the parking brakes; potentially resulting in a vehicle roll away. Should this occur, the unattended roll away vehicle could strike a bystander or cause property damage. Correction: Dealers will install a check valve repair kit. |
|---|---|
| 2003179 | 2003-07-29. Suspension. On certain vehicles, manufacturing defects in the front axle unitized hubs may cause premature spalling of the wheel bearings. This condition will lead to eventual breakdown of the bearing and potential loss of vehicle control amidst the presence of warning signals such as activation of ABS warning light, steering wheel vibration, brake drag, noise and vehicle pull. Correction: Dealer will replace both front wheel hubs. |
| 2003158 | 2003-06-19. Other. On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: Dealers will replace the bracket pins. |
| 2002222 | 2002-11-21. Other. On certain truck-tractor models equipped with ConMet Simplex stationary or sliding fifthwheels, the clinch pins that retain the fifthwheel pivot pins may not be fully installed. Correction: The fifthwheel will be inspected, and missing pins will be replaced. |
| 2002001 | 2002-01-02. Brakes. Certain heavy-duty trucks equipped with Meritor Wabco pneumatic Antilock Brake System (ABS) Valve Packages. The assembly bolts on these valve packages were not tightened correctly. Bolts torque below specification will not reliably prevent air leakage at the affected ABS Valve Package interface joints once the component begins normal vehicle operation. If air leaks develop at any of the ABS Valve Package interface joints, brake system pressure reductions could occur during braking or normal operation with units equipped with the traction control option, potentially extending stopping distances, possibly resulting in a vehicle crash. Correction: Dealers will tighten the fasteners to the proper specification. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.