Recalls that may apply to the 1987 Ford Taurus
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Steering are shown.
| 86V144000 | 1986-10-28. STEERING: STEERING WHEEL/HANDLE BAR. STEERING SHAFT ASSEMBLIES CONTAIN LOWER SHAFTS OF INSUFFICIENT LENGTH FOR PROPER ATTACHMENT TO THE SHAFT INSULATOR FLANGE. CONSEQUENCE OF DEFECT: SHAFT COULD SEPARATE, RESULTING IN TOTAL LOSS OF STEERING CONTROL AND A POSSIBLE ACCIDENT. Built 1986-10-01 to 1986-10-01. |
|---|
| 1998250 | 1998-12-22. Steering. On certain vehicles located in Manitoba, Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador, the lower sub frame mount plate nut may corrode and fail due to exposure to road salt. This could result in loss of structural integrity of the subframe mount attachment. Detachment of the body mounts at the rear corners of the sub frame which supports the engine and transmission, allows the rear corners of the sub frame to drop. Should both rear corners drop, steering control would be adversely affected. Correction: Dealers will install subframe rear mount bolts, reinforcement plate and plate nuts. |
|---|---|
| 1986124 | 1986-11-06. Steering. THE STEERING COLUMN LOWER SHAFT MAY NOT BE PROPERLY ATTACHED TO THE STEERING SHAFT INSULATOR FLANGE. IF THE SHAFT WERE TO SEPARATE, TOTAL LOSS OF STEERING CONTROL WOULD OCCUR WITHOUT PRIOR WARNING, RESULTING IN A POSSIBLE VEHICLE CRASH. CORRECTION: VEHICLES WILL BE INSPECTED AND, IF NECESSARY, THE STEERING SHAFT ASSEMBLY WILL BE REPLACED. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.