Recalls that may apply to the 1986 Ford Ranger
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Electrical are shown.
| None found. |
| 1988136 | 1988-10-05. Electrical. On certain vehicles, wiring for the power lumbar seat system was routed directly beneath the seat cushion springs on the side of the cushion. This could result in the insulation being abraded by the seat springs resulting in a possible short circuit with the potential for a fire in the cushion pad or trim cover. Correction: Power lumbar seat wiring will be modified and a 15 amp fuse will be added to the wiring under the seat on Aerostars. On Bronco II and Ranger Super Cab vehicles the 30 amp circuit breaker, located in the fuse panel, will be replaced with a 15 amp fuse. |
|---|---|
| 1985106 | 1985-09-30. Electrical. VEHICLES MAY CONTAIN THE POTENTIAL FOR A SHORT CIRCUIT BETWEEN THE FUEL INJECTOR RETURN AND BATTERY ELECTRICAL CIRCUITS CAUSED BY THE PROXIMITY OF THE WELDS IN THE WIRING ASSEMBLY ENGINE CONTROL SENSOR. SHOULD A SHORT CIRCUIT OCCUR, THE ELECTRIC FUEL PUMP MAY ENERGIZE AND SOME FUEL INJECTORS MAY OPEN. THIS COULD RESULT IN FUEL DISCHARGING INTO THE ENGINE EVENTUALLY LEAKING FROM THE EXHAUST SYSTEM TO THE GROUND AND CREATING THE POTENTIAL FOR A VEHICLE FIRE. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.